ASG BLG-OPC Manuel opérationnel - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel opérationnel pour {nom_de_la_catégorie} ASG BLG-OPC. ASG BLG-OPC 17 pages.
Imprimer la pageScrew Counter
Changing the Setting Mode
Press the F1 Button for more than 2 seconds in the normal mode. "P"
will be displayed in the function display section and the mode will be
changed to the setting mode.
Setting Mode
Pressing the F1 button allows you to scroll through each setup
function. Refer to "Setting Function List" for the setting function
details. Note the number of motor revolutions is displayed up to triple
digits.
(Count)
(Reverse Count Timer)
(System)
Value Setting for Each Setup Function
•
Verify the hundreds (3rd) digit. Press the F2 Button to change
the figure position for setting.
•
Change the value. Pressing the F3 button increases the value
one by one. Press and hold the F1 button until the buzzer
sounds twice to save the change.
•
Press and hold the F1 button until the buzzer sounds twice
to save the change.
Display the 3rd Digit
Initial
Change the set value
Press F3 to enter 0
Change Cycle Count
•
Press F1 Button for more than 2 seconds to increment to
display number. Follow the procedure described in "Value
Setting for Each Setup Function". The count can be set between
1 and 99.
Change the count.
Press F3 to make "8" blink; Press F3 to enter 5.
Turn the count ON/OFF
•
Press F1 Button for more than 2 sec. to turn the counter ON/
OFF
Counter: ON/OFF
Counter: ON
Counter: OFF
ASG, Division of Jergens, Inc.
S. Waterloo Road | Cleveland, OH
15700
HIOS BLG Series: BLG-BC2
Operational Manual
(Min. revolutions)
(Max. revolutions)
(Over Time/
(Total No. of the
Short Time)
driver shut off)
Press F3 to enter 2
Press F3 to save
| Phone: (
44110-3898
888) 486-6163
Note: The setting procedure is the same for all the settings except
for the "Counter ON/OFF Setting"
(Work Reset Timer)
(No Error Time for dou-
ble fastening)
| Fax: (
| Email: [email protected] | Web: www.asg-jergens.com
216) 481-4519