ASG TLB-D Manuel d'utilisation - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} ASG TLB-D. ASG TLB-D 6 pages. Brushless electric screwdrivers
Imprimer la pageTLB-D Brushless Electric Screwdrivers
Operation Manual
Counting Set-Up Instructions (Continued)
•
In the set-up, if Lt and LL show "02."it means 0.02, push P to adjust decimal.
•
During operation, LED will show three colors: OK is green light; NG is red light;
standby learning is orange light.
•
EA-BD PCB has three kinds of signal, OUTPUT OK1, OKALL and NG
•
Output users need input voltage to drive the buzzer, the input voltage can't be
over DC24V 10mA.
•
There is a new function in the screwdriver that will judge a NG if there is a start
signal and it is OFF before Lt.
Push both UP+DOWN set up the buzzer:
ON
Fastening a screw, completing work and mistaken operation, buzzer
will be on.
OFF
Wrong operation will be buzzed.
FF
Work completed and wrong operation will cause buzz.
EF
As one screw is fastened and work is completed, buzzer will be on; as
mistake made has no buzz.
ASG, Division of Jergens, Inc.
S. Waterloo Road | Cleveland, OH
15700
44110-3898
| Phone: (
| Fax: (
| Email: [email protected] | Web: www.asg-jergens.com | Revision: 8/24/2020 | Page 5 of 6
888) 486-6163
216) 481-4519
Counting Set-Up Instructions (Continued)
Ht/Lt Description:
•
Ht/Lt sets up the period of time. If the tool stops within the set period, it means
OK. In contrast, it will be (NG) if it stops before Lt or after Ht. The LT accepts 0.00,
but it can be increased or decreased in SELECT.
•
To shut down the count: If count needs be shut down, push P key for five seconds
until no figures on the panel, meanwhile LED 1 will show green light.
•
If set value need be reset during counting, push for three seconds.
•
Simulated-learning: While electric screwdriver is not used, push S key and then
push P key to enter simulated-learning procedure; SL(S)===SC(S)===At(S)===
Test Data===(P)
1. Show SL (Screw List), select UP/DOWN to change number and then push S (confirm)
2. Show SC (counting number), select UP/DOWN to change number and then push S (confirm)
3. Show At (automatic zero), UP/DOWN to change value; then push P (confirm)
4. Enter simulated-learning (LED 1 will keep flash)
•
LED light will flash in simulated-learning. Push P key to record value after
simulated –learning.
•
UP and P key can set up waiting time.
•
Push R key to restore to factory settings.