ASG DTT-L 200 Manuel de l'utilisateur - Page 15

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} ASG DTT-L 200. ASG DTT-L 200 15 pages. Digital torque testers

Imprimer la page
Main Menu (Continued)

Transducer State

This is used to check the status of the transducer. If you suspect that your transducer
has sustained an overload, check the status of the transducer immediately. To
access the Transducer State menu, press the MENU/ESC key, the display will show
main menu page. Use the UP and DOWN ARROW keys to move the cursor point to
TRANSDUCER STATE. Press the ENTER key. Press the UP and DOWN ARROW keys
to move the cursor point to VIEW and press the ENTER key.
•
Place the meter horizontally on a flat level surface and go to the main menu page
Use the UP and DOWN ARROW keys to move the cursor point to TRANSDUCER
•
STATE and press the ENTER key
•
The display will show the TRANSDUCER STATE menu page. Press the ESC key to
return to the main menu page
•
If the % offset is greater than 10%, please contact ASG to arrange for evaluation
•
Transducer state offset number is for reference only and does not determine
whether the transducer is yielded
•
These values are given only as an indicator – the need for repair may vary
according to the individual characteristics of the transducer

About

This shows the information regarding your tester (model, capacity, firmware revision,
serial number).
•
To access the About menu, press the MENU/ESC key, the display will show main
menu page. Use the UP and DOWN ARROW keys to move the cursor point to
ABOUT. Press the ENTER key. The display will show the ABOUT menu page.
Press the ESC key to return to the main menu page
•
ASG, Division of Jergens, Inc.
S. Waterloo Road | Cleveland, OH
15700
DTT-L Series Digital Torque Testers
User Manual
| Phone: (
44110-3898
888) 486-6163
| Fax: (
| Email: [email protected] | www.asg-jergens.com
216) 481-4519
Page 15 of 15