Doit ESP-F1 Manuel - Page 19

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Doit ESP-F1. Doit ESP-F1 19 pages. Wifi module

This device is intended only for OEM integrators under the following conditions:

1) The antenna must be installed such that 20 cm is maintained between the antenna and users,

and

2) This device and its antenna(s) must not be co‐located with any other transmitters except in

accordance with FCC multi‐transmitter product procedures. Referring to the

multi‐transmitter policy, multiple‐transmitter(s) and module(s) can be operated

simultaneously without C2PC.

3) For all products market in US, OEM has to limit the operation channels in CH1 to CH11 for 2.4G

band by supplied firmware programming tool. OEM shall not supply any tool or info to the end‐

user regarding to Regulatory Domain change.

USERS MANUAL OF THE END PRODUCT: In the users manual of the end product, the end user

has to be informed to keep at least 20cm separation with the antenna while this end product is

installed and operated.

The end user has to be informed that the FCC radio‐frequency exposure guidelines for an

uncontrolled environment can be satisfied. The end user has to also be informed that any

changes or modifications not expressly approved by the manufacturer could void the user's

authority to operate this equipment. If the size of the end product is smaller than 8x10cm, then

additional FCC part 15.19 statement is required to be available in the users manual: This device

complies with Part 15 of FCC rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference and

(2) this device must accept any interference received, including interference that may cause

undesired operation.

LABEL OF THE END PRODUCT: The final end product must be labeled in a visible area with the

following " Contains FCCID: 2AL3B‐ESPF1". If the size of the end product is larger than 8x10cm,

then the following FCC part 15.19 statement has to also be available on the label: This device

complies with Part 15of FCC rules.

Operation is subject to the following two conditions:

(1) this device may not cause harmful interference and

(2) this device must accept any interference received, including interference that may cause

undesired operation.

-OEM integratoris responsible for ensuring that the end-user has no manual

instructions to remove or install module.

-That module is limited to installation in mobile or fixed applications,

according to Part 2.1091(b)

-Separate approval is required for all other operating configurations,

including portable configurations with respect to Part 2.1093 and different

antenna configurations