Ashcroft 2274 XU1 Manuel d'utilisation - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Ashcroft 2274 XU1. Ashcroft 2274 XU1 13 pages. Digital industrial gauge

Imprimer la page

G G A A U U G G E E I I N N S S T T A A L L L L A A T T I I O O N N : :

The Ashcroft digital industrial gauge comes standard with either

Good piping practices recommend using teflon tape or a pipe sealant on the gauge

threads. Utilize a

⁄

˝ (3˝ case),

1 6

tighten the gauge to the process.

NEVER TIGHTEN GAUGE THREADS BY HOLDING THE BODY OF THE GAUGE. DOING SO

MAY DAMAGE THE GAUGE AND MAKE THE GAUGE INOPERABLE.

P P A A N N E E L L M M O O U U N N T T I I N N G G D D I I M M E E N N S S I I O O N N S S

.17

HOLE

CUTOUT

DIAMETER

3.406

⁄

)

4.00

Battery Installation and Replacement:

The Type 2074 comes standard with batteries installed. The 3˝ case uses qty (2) AA alka-

line batteries, the 4

⁄

˝ case uses qty (2) C alkaline batteries. Use either Duracell MN2400,

MX2400 or Energizer E92BP, X92RP AAA alkaline, non-rechargeable batteries.

Batteries have a life of approximately 1500 hours (3˝ case). 3600 hours (4

Battery life is dependent on gauge usage, backlite settings and power off settings. When

the lower bar of the battery icon of the gauge display flashes, the gauge has approxi-

mately 7 hours of life remaining.

To replace the batteries (3˝ case):

1) Remove the single screw on the back of

the gauge case.

2) Hold the keypad in the palm of hand.

3) Carefully remove the two batteries from

the holder and replace batteries. Use only

AA alkaline non-rechargeable batteries.

To provide maximum battery life, replace

both batteries.

Pipe to which gauge is attached

must be properly grounded.

Ashcroft Inc.

250 East Main Street

Stratford, CT 06614-5145

Tel: 203-378-8281

Fax: 203-385-0602

e-mail: [email protected]

www.ashcroft.com

⁄

˝ (4

⁄

˝ case) wrench on the wrench flat of the gauge to

MOUNTING

1.860

6˝ RING

DIA.

3˝ CASE

To replace the batteries (4

1) Remove the ring on the front of the

2) Looking at the gauge case, carefully

3) Lay the gauge, face down on a flat sur-

4) Carefully remove the two batteries from

Notes:

1) Do not mix ages or brands of batteries.

2) Do not replace batteries in hazardous

– 24 –

⁄

CLAMPING RING (1278G ONLY)

WASHER

SPACER POST

RING

(3 REQ'D)

"B" (3 REQ'D)

5.65˝

PANEL

OPENING

5/16˝ MAX PANEL

THICKNESS

⁄

˝ CASE

PANEL

gauge case.

pull the front face out of the case.

face.

the holder and replace the batteries.

Use only C alkaline non-rechargeable

batteries. To provide maximum battery

life, replace both batteries.

areas.

⁄

NPT connection.

⁄

˝ case).

⁄

˝ case):