CYP CH-1602TXR Manuel d'utilisation - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} CYP CH-1602TXR. CYP CH-1602TXR 16 pages. Hdmi over hdbaset transmitter and receiver with optical audio return oar
Imprimer la page
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Transmitter's Front Panel
DC 48V POWER AUDIO IN
+
-
L
1
1
DC 48V & POWER LED: Plug the 48V DC power adapter into this
port and connect it to an AC wall outlet for power. The LED will
illuminate to indicate the unit is on and receiving power.
AUDIO IN: Connect to the stereo analog output of a device such
2
as a CD player or PC to extend it to the Receiver's AUDIO OUT L/R
port.
IR IN 2: Connect to the provided IR Extender to extend the IR
3
control range of remotely located devices. Ensure that the remote
being used is within direct line-of-sight of the IR Extender.
4
IR OUT 1: Connect to the provided IR Blaster to transmit IR signals to
devices within direct line-of-sight of the IR Blaster.
RS-232 IN: Connect to a PC, laptop or other serial control device
5
with a 3-pin adapter cable for the extension of RS-232 signals to
the Receiver. When receiving commands from the Receiver side,
depending on your equipment's pinout, the Tx and Rx pins might
need to be reversed.
UPDATE: This is reserved for firmware update use only. During
6
normal operation the dipswitch should be set to the right.
3
IR IN2 IR OUT1
R
2 3 4
RS-232 IN
UPDATE
TX
RX
5
6