Ashdown JOHN MYUNG DOUBLE DRIVE Manuel de l'utilisateur - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Ashdown JOHN MYUNG DOUBLE DRIVE. Ashdown JOHN MYUNG DOUBLE DRIVE 17 pages.

Imprimer la page

ASHDOWN ENGINEERING - DOUBLE DRIVE

REAR PANEL

DIRECT INJECT (D.I.)

A balanced D.I. Is provided on a latching XLR socket. This is Post E.Q. and effects

signal. The output signal from this XLR socket is set to a level and impedance

suitable for connecting directly into the input of a mixing desk for either Direct

Injection into the PA system or for recording. This must ONLY be used into a

balanced input, it is not intended for any other type of connection.

JACK INPUT

Use this to plug your instrument cable in or plug in from another pedal output.

JACK OUTPUT

This is a jack output to your amp or another pedal on your board.

DOUBLE DRIVE

USER GUIDE

SPECIFICATIONS:

Inputs

Input

Outputs

D.I.Output

Power Supply

2.1mm Plug 9V Centre pin NEGATIVE @ 100 mA.

Best results will be obtained with a LINEAR regulated supply (ie transformer type),

the use of switching type adapters may lead to the introduction of unwanted noise.

IMPORTANT! Use correct POLARITY Power Supply, the use of the wrong power

supply will invalidate the warranty and repairs required due to the use of the wrong

supply may incur a charge.

Impedance - 3.9M ohms

Input impedance 100k

420 ohms balanced , Transformer isolated, optional ground lift

USER GUIDE