CYP CH-506TX Manuel d'utilisation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} CYP CH-506TX. CYP CH-506TX 16 pages. Hdmi/ir/rs-232 over single cat5e/cat6 extender
Également pour CYP CH-506TX : Manuel d'utilisation (16 pages), Manuel d'utilisation (13 pages), Manuel d'utilisation (16 pages), Manuel d'utilisation (9 pages)

Imprimer la page
CYP CH-506TX Manuel d'utilisation

6. OPERATION CONTROLS AND FUNCTIONS

6.1 Transmitter Front and Rear Panels

Front
IR2 Extender
RS232 In
IR1 Blaster
1
2
1
RS-232 In: Connect to a PC/laptop or RS-232 enabled device(with
supplied 3.5 mm phone jack to D-Sub 9 pin adaptor) for the transmission
of RS-232 commands.
2
IR2 Extender: Connect to the supplied IR extender cable for IR signal
reception. Ensure that remote controller being used is within the direct
line-of-sight of the IR extender.
3
IR1 Blaster: Connect to the supplied IR blaster cable for IR signal
transmission. Place the IR blaster in direct line-of-sight of the equipment
to be controlled.
4
HDMI In: Connect to HDMI source equipment such as a DVD or Blu-ray
player.
5
DC 5V: Plug the 5 V DC power supply into the unit and connect the
adaptor to an AC outlet.
6
Link: The yellow LED will illuminate when both the input and output
CAT5e/6/7 signals are connected.
7
Power: This green LED will illuminate when the device is connected to a
power supply.
8
CAT5e/6 Out: Connect to the receiver unit with a single CAT5e/6/7 cable
for transmission of all data signals.
3
HDMI In
3
4
Rear
DC 5V
Power
Link
CAT 5e /6 Out
5
6
7
8
3