CYP CH-506TXL Manuel d'utilisation - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} CYP CH-506TXL. CYP CH-506TXL 16 pages. Hdmi/ir/rs-232 over single cat5e/cat6 extender
Également pour CYP CH-506TXL : Manuel d'utilisation (13 pages), Opération Ma (16 pages)
Imprimer la page
6.2 Receiver Front and Rear Panels
Front
IR1 Extender
RS232 Out
IR2 Blaster
1
2
1
RS-232 Out: Connect to the device that is to be controlled (with
the supplied 3.5mm phone jack to D-Sub 9-pin adaptor) by RS-232
commands.
2
IR1 Extender: Connect to the supplied IR extender cable for IR signal
reception. Ensure that remote being used is within the direct line-of-sight
of the IR extender.
3
IR2 Blaster: Connect to the supplied IR blaster cable for IR signal
transmission. Place the IR blaster in direct line of sight of the equipment
to be controlled.
4
HDMI Out: Connect to a HDMI equipped TV/monitor for display of the
HDMI input source signal.
5
DC 5V: Plug the 5 V DC power supply into the unit and connect the
adaptor to an AC outlet.
6
Link: The yellow LED will illuminate when both the input and output
CAT5e/6/7 signals are connected.
7
Power: This green LED will illuminate when the device is connected to a
power supply.
8
CAT5e/6 In: Connect to the transmitter unit with a Single CAT5e/6/7
cable for transmission of all data signals.
4
HDMI Out
3
4
Rear
DC 5V
Power
Link
5
6
7
CAT 5e /6 In
8
4