Ashford DOUBLE TREADLE KIT Instructions - Page 2

Parcourez en ligne ou téléchargez le pdf Instructions pour {nom_de_la_catégorie} Ashford DOUBLE TREADLE KIT. Ashford DOUBLE TREADLE KIT 2 pages. Traveller single or double drive
Également pour Ashford DOUBLE TREADLE KIT : Instructions (2 pages), Manuel d'instructions (6 pages), Instructions (2 pages)

Imprimer la page

7. Locate one end of the double treadle rail into the hole in the leg in the base. Place the other leg onto the other end. Push

the leg back into the base. Check the treadle rail moves freely. Hammer the leg in and secure with the screw.

8. Replace the wheel into position. Note: the hub pin is on the same side as the con rods.

9. Push the double treadle crank (with the inner con rod attached) through the wheel supports and into the hub. There are two

holes in the crank. One will fit your wheel.

10. Place the nail down the hub pin slot and rotate the crank until it fits into the hole in the crank. Remove the nail and replace

it with the hub pin.

11. Slide the inner shell of the conrod universal joint onto the

crank until it clicks into the groove. Then click the front

conrod onto the universal joint on the crank.

13. Lubricate all moving parts with Ashford Spinning Wheel Oil. Now you can enjoy spinning on your new Ashford Double

Treadle Kit.

12. Insert the front conrod into the large slot in left hand

treadle board. Hold the conrod joint with one hand on

either side of the treadle board. With both hands, turn the

conrod joint a ¼ turn. Stretch and slide it

small slot and turn it back a ¼ turn until it clicks into

place.Repeat the sequence for the rear conrod and the

right treadle board.

into the