Ashford KNITTERS LOOM STAND VARIABLE WIDTH Instructions - Page 2

Parcourez en ligne ou téléchargez le pdf Instructions pour {nom_de_la_catégorie} Ashford KNITTERS LOOM STAND VARIABLE WIDTH. Ashford KNITTERS LOOM STAND VARIABLE WIDTH 2 pages. For 30cm (12"), 50cm (20") or 70cm (28") looms

Ashford KNITTERS LOOM STAND VARIABLE WIDTH Instructions
Knitters Loom 30cm (12")
Attach the 2 metal brackets to the 2 legs with 12mm (½")
round head screws into the pre drilled holes. Attach the
footrest to one leg and one foot as illustrated with a 50mm
(2") bolt and barrel nut and lightly tighten with the Hex Key.
Note the tapered leg fits snuggly into the tapered rebate in
the foot. Repeat for the other side. Store the 2 extender rails
and 32mm (1 ¼") bolts and barrel nuts for future use with
either a 50cm (20") or 70cm (28") Knitters Loom. Proceed to
Step 2.
Knitters Loom 50cm (20") or 70cm (28")
1. Secure the footrest to both extender rails using the
appropriate holes with 32mm (1 ¼") bolts and barrel nuts.
2. Attach this footrest assembly to one leg and one foot as
illustrated with 50mm (2") bolts and barrel nuts and lightly
Ashford Handicrafts Limited
415 West Street, Ashburton 7700, New Zealand
Telephone 64 3 308 9087
[email protected] www.ashford.co.nz
tighten with the Hex Key. Note the tapered leg fits snuggly into
the tapered rebate in the foot. Repeat for the other side.
3. Loosen the side knobs on your knitters loom. Then locate
the loom and bolts into the slots in the metal brackets
keeping the washers between the bracket and the knob.
4. Note the support braces are left
and right. Check they are on the
correct side and then attach them
to the legs with 45mm (1 ¾") bolts
washers and knobs.
5. Sit at the loom and adjust the
angle of the loom and footrest to
suit. Raise the support braces under the front cross rail and
tighten all knobs and bolts.
6. Store the Hex Key in the hole in the footrest so you can
retighten the bolts later if required.
Enjoy weaving on your Knitters Loom!
12mm (½") screws
Metal Bracket