Ashford e-Spinner 3 Manuel d'instructions - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} Ashford e-Spinner 3. Ashford e-Spinner 3 6 pages.
Également pour Ashford e-Spinner 3 : Manuel d'assemblage (6 pages)
Imprimer la page
Alternate Mode
(while your foot
is on the foot
switch)
The e-Spinner 3 will operate only while your foot is on
the foot switch. Lift your foot off and the e-Spinner 3
will stop.
Spinning
IMPORTANT: Make sure the flyer has snapped fully into
the bearing before starting spinning.
1. Tie a piece of yarn, called a leader, approx. 1metre (1
yard) long to the bobbin. Thread it through the flyer yarn
guides with the black inserts on the right-hand side of
the flyer and out through the orifice.
leader
2. Have your prepared fibres ready to spin.
3. Adjust the tension knob until both springs are only
just beginning to stretch.
4. Check the S TWIST/Z TWIST switch is on Z TWIST
(down) and the SPEED control is on SLOW. Switch
the ON/OFF switch to ON. Gradually turn the SPEED
control clockwise until the flyer starts to turn slowly.
S TWIST
Z TWIST
Lightly put your foot
on the foot switch and
turn the power ON.
NOTE: Ensure the e-Spinner 3 is switched OFF before
removing the foot switch plug.
IMPORTANT: Avoid tripping over or yanking on the foot
switch or AC/DC adapter cords as this can damage or
break the plugs and void your warranty. Please remove
both cords when transporting your e-Spinner 3.
5. Allow the leader to start feeding in and commence
drafting the prepared fibres onto it.
6. Adjust the SPEED control and tension knob to achieve
a comfortable speed and take up. Use the ON/OFF switch
or foot switch (rather than the speed control) to stop
the motor when moving the position of the yarn guide.
This will ensure you recommence at the same speed.
- If your yarn breaks, draft a thicker yarn, increase the
speed a little, reduce the brake tension and oil the
bearings.
- If your yarn kinks, is over twisted or won't feed on,
reduce speed and increase the brake tension a little.
Changing the bobbin
- Turn the motor off using the ON/OFF switch or foot
switch. Use 2 hands, one either side of the front bearing
to lift and snap the flyer out of the bearing. Pull the flyer
towards you out of the flexible drive.
- Change the bobbin, then hook the brake band back
over the flyer whorl, slide the flyer back into the flexible
drive and snap the flyer down into the front bearing.
Lubrication
- We recommend Ashford Spinning Wheel Oil be
regularly applied to the front flyer and bobbin
bearings.
- The bobbin and flyer must revolve freely and
independently of each other.
- A drop of Vaseline or oil may be applied to the
flexible motor drive to make bobbin changing
easier and to minimize noise.
- The ball bearings in the motors may be noisy
for the first 5-10 minutes as they "run-in" and the
grease is dissipated evenly.
5
INPUT