Cypress CY3280-BSM Manuel de démarrage rapide

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Cypress CY3280-BSM. Cypress CY3280-BSM 2 pages. Universal capsense simple button module kit

Imprimer la page

CY3280-BSM UNIVERSAL CAPSENSE

1. Insert the kit CD in the CD drive.

2. Install kit content, PSoC Designer, PSoC

Programmer, and Bridge Control Panel.

Note The hardware prerequisites for this kit are

the CY3280-20x34 Universal CapSense

Controller (UCC) board and MiniProg1.

1. Open PSoC Programmer and click

File > File Load. Browse and load the

CY3280_BSM_20x34.hex file.

2. Click the Connect button.

3. Click the Program button to program the

device.

4. Click the Toggle power button to power

the board.

Note The hex file is located at:

<Install directory>\Cypress\CY3280

BSM\<version>\Firmware\20x34_CSA\

CY3280_BSM_20x34\CY3280_BSM_20x34\

SIMPLE BUTTON MODULE KIT

QUICK START GUIDE

1. Connect the CY3280-BSM board to the

CY3280-20x34 UCC board's P2 connector.

2. In the CY3280-20x34 board, place the

jumper on header J1 to short pins 2 and 3. In

the CY3280-BSM board, place the jumper on

header J2 to short pins 2 and 3.

Connect MiniProg1 to the CY3280-

20x34 UCC board's ISSP connector (J3).

Connect it to your PC using a USB cable.

1. When you touch a button, the

corresponding LED on the module board

lights up, indicating the button you

touched.

2. Next, touch the same buttons to turn

off the LED. You can touch multiple

buttons at the same time.