Ashley 2080112 Manuel - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Ashley 2080112. Ashley 2080112 17 pages.
Imprimer la page
6. Power Bu�on: The Power Bu�on is designed to disable the power opera�on. It is in the cable that connects the motor to the
transformer. It is a press bu�on. When the bu�on is pressed to the off posi�on, the Green Light on the Power bu�on will not
display. When the bu�on is in the on posi�on, the Green Light in the Power Bu�on will display and the unit will operate.
7. Connect the power cord into the Power Transformer.
8. Connect the power cord into an electrical outlet near where the chair will be used.
WARNING: Clear area below chair before lowering to reduce risk of injury or death.
The power bu�on is intended to allow you to disable the chair func�on
To stop the chair from func�oning using the power bu�on, press the bu�on so the LED light is off.
If the chair is not func�oning, check the plug in and connec�on of the cords first (The order is A-B-C-D). If all
connec�ons are good, verify the LED is lit on the power bu�on. See Figure B.
Ensure that all cords are placed properly such that they will not interfere with the chair during opera�on .
9. Press the
on the wand to li� the chair and the
10. Installa�on of back-up ba�eries: 9 Volt back-up ba�eries will operate the chair from the reclined posi�on to the sea�ng
posi�on one cycle in case of a power failure. If a power failure occurs and the chair is cycled, the 2 -9 volt ba�eries must be
replaced. Unused ba�eries must be replaced annually.
1.
Make sure unit is unplugged before proceeding.
2.
Remove the sliding door on the side of the Power Transformer to locate where the two 9 volt ba�eries are to be
installed.
3.
Install two 9 volt ba�eries, Batteries not included
4.
Replace door on the Power Transformer.
FIGURE B
SIGNATURE DESIGN BY ASHLEY®
bu�on on the wand to lower or recline the chair.
All Rights Reserved.
January, 2016
AS-HM-1
Page 4 of 17