Cypress EZ-USB HX2LP CY4606 Manuel de démarrage rapide
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Cypress EZ-USB HX2LP CY4606. Cypress EZ-USB HX2LP CY4606 2 pages. Reference design kit
Imprimer la page
CY4606 EZ-USB
1
Insert the kit CD/DVD into the CD/DVD
drive of your PC. Review kit contents.
3
Plug the wall mounted power supply into an
AC power receptacle providing power in the
range 100 V to 240 V, 50 Hz or 60 Hz.
Connect the power supply plug to the hub's
'DC Supply' jack J12.
®
HX2LP™ REFERENCE DESIGN KIT
QUICK START GUIDE
2
Place jumper on J5 (power status) and J6
(port status) to enable LEDs D1 and D3-D10.
Power LED D1 glows only in self-powered
mode. The green LEDs (D3, D5, D7, D9)
indicate that the downlink port is enabled.
The amber LEDs (D4, D6, D8, D10) indicate
the port has an exception condition.
4
To connect to the PC, plug the USB A to B
cable into the hub's 'Up Link' connector P1.
Plug the other end of the cable into one of the
PC's host controller ports. The hub enumerates
as a 'Generic USB Hub'. The hub is now
ready for any low speed, full speed, or high
speed devices to be plugged into the ports.
For the 4-port hub, the board is labeled
PORT1, PORT 2, PORT 3, and PORT 4.