Dolmar 111i Manuel d'entretien - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Dolmar 111i. Dolmar 111i 19 pages.
Imprimer la page
- 1. Table of Contents
- 2. Index Technical Data
- 3. Special Tools
- 4. Chain Brake
- 5. Clutch, Clutch Drum
- 6. Oil Pump
- 7. Ignition System
- 8. Starter Assembly
- 9. Carburettor, Intake System
- 10. Cover System, Air Filter
- 11. Vibration Dampers, Handle
- 12. Fuel Tank
- 13. Cylinder and Piston
- 14. Crankcase, Crankshaft
- 15. Checking Operations
- 16. Torques
DOLMAR GmbH
01 Chain brake
01-02 Releasing the chain brake
Insert the clutch drum (1) and by levering
down the brake gate, using a screwdriver (2),
release the chain brake.
6
8
01-02 Replacing the brake band
A damaged or defective brake band (8) and a
damaged or defective tension spring must be
replaced without delay (6).
Caution: Safety components
01-04 Removing the hand guard
Remove the nut (11) and push the screw (12)
in direction of the cylinder. Unscrew screw
(13) on the starter side and remove the insert
(14).
2
1
12
11
5
4
6
7
01-02 Relieving the tension spring
To remove the brake band it is necessary to
remove the cover plate (3). For this purpose
unscrew screws (4) and remove retaining
rings (5). Relieve the tension spring (6) by
levering it off the housing peg (7).
10
01-02 Pretensioning the tension spring and
the brake gate
Following the installation of the brake band,
engage the tension spring in the brake gate
(9) and using the pulling hook (10) no.
950.237.000 pass the spring over the peg (7).
13
14
01-04 Fitting the hand guard
When fitting the hand guard, ensure that the
compression spring (16) is installed correctly.
3
5
4
9
16
11
12
5