Cypress CP-255H Manuel d'utilisation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Cypress CP-255H. Cypress CP-255H 12 pages. Pc/hd to 1080p hdmi scaler box video scaler
Également pour Cypress CP-255H : Manuel d'utilisation (11 pages), Manuel d'utilisation (16 pages)

Imprimer la page

3. HDMI (DVI) in: Connect this HDMI input connector to the HDMI output

4. AUX (DVI) audio in: This audio input should be used only when a DVI source is

5. HDMI out: Scaled digital HDMI output. Connect this output to the HDMI or

DVI input of your HD display.

6. Power jack: Connect to the 5V 2.6A DC power adaptor.

Remote Control and functions:

1. Power: Press the button once to power on the CP-255H. Press again to enter

standby mode.

2. Input: Press the button repeatedly to toggle through various input sources as

follows.

3. HD input: Press the button to directly select component input.

4. PC input: Press the button to directly select PC input.

5. HDMI/DVI input: Press the button to directly select DVI (or HDMI) input.

6. Output resolution:

Select buttons: Press any one of the button to directly

7. MENU: Press the button to bring up OSD main menu page.

8. Exit: Press the button to exit from a sub menu or main

menu.

9. Up/Down/Left/Right: Press the Up/Down button to move

10. OK (Enter): Press the button to confirm your selection.

11. Reset: Press the button to reset the unit's firmware setting

to the factory default value.

12. Auto Adjust: Press the button to optimize the position of the picture

connector of your HDMI source equipment using certified HDMI

cable. Or connect this HDMI input connector to the DVI output

of your DVI source equipment using DVI cable together with

DVI to HDMI adaptor. The HDMI input resolution covers

480i~1080p, and VGA~WUXGA.

connected to the HDMI input. The CP-255H will convert

DVI and AUX audio input to HDMI output.

This audio input can not be used when input is HDMI signal.

Component

select output resolution.

For other output resolutions that are not

covered by these buttons please enter

Menu/Output page to select them.

the highlight bar to your desired

parameter during the OSD operation.

Press the Left/Right button to increase/

decrease the setting value of a

selected parameter.

(picture centering) on the screen.

HDMI