Ashly Power Amplifiers FET-200 Manuel d'utilisation - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Ashly Power Amplifiers FET-200. Ashly Power Amplifiers FET-200 14 pages. Mos-fet power amplifiers
Également pour Ashly Power Amplifiers FET-200 : Manuel d'utilisation (15 pages)
Imprimer la page
This
manual will explain the proper installation and use of Ashly
amplifiers
and
their
controls.
Please read it carefully and refer to it
in
case
of
difficulty.
UNPACKING
As
part
of our system of quality control,
every Ashly product is
carefully
inspected before leaving the factory to ensure flawless appearance.
After un¬
packing please inspect for any physical damage.
iave the shipping carton and
all packing materials,
as they were carefully designed to reduce to a minimuiu
the possibility of transportation damage suould the unit again require packiu,;
and shipping.
In the event that damage has occurred, immediately notify your
dealer so chat a written claim to cover the aamages can be initiated.
THE
RIGHT
TO
ANY
CLAIM AGAINST A PUBLIC CARRIER CAN BE
FORFEITED
IF
THE
CARRIER
IS
NOT
NOTIFIED PROMPTLY AND IF THE
SHIPPING
CARTON
AND
PACKING
MATERIALS
ARE NOT AVAILABLE FOR INSPECTION BY THE CARRIER.
SAVE ALL PACKING
MATERIALS UNTIL THE CLAIM HAS BEEN SETTLED.
INSTALLATION
Ashly
MOS-FET
amplifiers are designed to mount in a standard
ly"
equipiacnf
rack.
Since forced-air cooling is employed, it is not necessary to leave any
ventilation space above or below the amplifier.
This permits efficient use of
rack
space
and
multiple stacking of amplifiers.
The
only
precaution
to
observe
is
to
leave the front panel air inlets and rear
panel
fan
outlet
unobstructed.
The
use
of four front panel screws is recommended to evenly
distribute
the
stress on the panel.
The amplifier chassis is sufficiently strong to support
itself
by the front panel alone in permanent installations or where the
rack
is
moved
only occasionally.
For amplifiers which will spend much of
their
time in transit, it is suggested that some method of rear support be used.
Connect all amplifiers to a 3-wire grounded outlet supplying 120 Volts 50-60Hz
Maximum power consumption is 600 watts. Maximum current required is 5 amps.
4