Ashly FR-8 Manuel d'utilisation - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Ashly FR-8. Ashly FR-8 12 pages. Fr remotes network remote controls
Également pour Ashly FR-8 : Manuel d'utilisation (17 pages), Spécification du produit (2 pages)

Imprimer la page

Operating Manual - FR-8 and FR-16 Remote Level Controller

Switch Button LED Function:

enable (green) for each fader, but can be alternately set to indicate signal level. When set for signal

level mode, the LEDs use green and amber to indicate the post-fader signal level in dBu at the point

of gain control for each fader. Every fader's LED transition points can be individually set.

LED Brightness:

of four levels to match ambient room lighting. The factory default is for the brightest setting.

Clear All:

window and returns them to factory default settings. It also clears the FR device target security user

name and password. Note: individual fader parameters can be cleared by clicking on any control for

that fader and then clicking the pop-up "Clear Fader" button associated with that fader.

Fader Control Features:

ment of the targeted device, fader mode, device channel, mixer sub-channel (if in mixer mode), fader

scaling, signal LED breakpoints (if the switch button LEDs are selected for signal level mode), and

assign to master fader. An individual fader clear function button appears when editing any control

point in a fader row. This returns that fader's parameters back to default settings.

Fader:

The total number of faders available on the FR remote are shown here, either 8 or 16.

Device:

Each fader can be programmed to control one exclusive NE device available in the

drop down menu, or to be inactive.

Mode:

Once a target DSP device has been selected, the fader can operate in one of two

modes, Mixer Mode or I/O Level Control Mode.

Mixer Mode - In mixer mode, the fader is first assigned to the target device's output

channel mixer, then assigned to a mixer sub channel, whereby the fader acts as a level control corre-

sponding directly to one of that mixer's input sources. The mixer sub channel feature is only avail-

able in mixer mode.

I/O Level Control Mode - I/O level control mode offers individual assignment of

faders to single input or output channel DSP gain controls on the targeted device, whereby the fader

works along with the DSP gain function. For controlling a stereo signal, one FR fader can control

more than one device channel by linking input or output gain functions within the target device.

Fader Scaling

the FR fader will use the full range of the DSP gain function under its control. An upper or lower

fader limit can be assigned to prevent insufficient or excessive audio level.

LED Level Transition Points -

mode, the two thresholds at which point the green signal LED first turns on and then transitions from

green to amber can be defined by the user. Factory default transition points are -22dBu for green and

+14dBu for amber.

Master Fader Assignment

control by the master fader. The factory default is for all faders to be assigned to the master fader. If a

fader appears to be functioning but has no effect on level, check that the master fader is not muted or down.

The overall brightness of FR-8 and FR-16 LEDs can be adjusted to one

This button clears the control parameters of all faders in the configuration

- The gain range for target DSP gain stages is -50dB to +12dB. By default,

- Faders can be individually selected for or removed from

All switch LEDs normally indicate mute (red) or

Individual fader control parameters include assign-

When the switch button LEDs are set to signal level