Dolphin BC 2012 Manuel de l'utilisateur - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Dolphin BC 2012. Dolphin BC 2012 12 pages. Automatic velocity hand dryer

Imprimer la page

Installation procedure

Use 220-240V 50Hz ~ supply (Do not use if power supply

is exceeding rated voltage +/-10%.

Use a power cord that is between 2mm² and 2.5mm²

(A drop in voltage is possible if the power cord run

exceeds 11m in length, so we recommend using 2.5mm²

cord). Do not install above a fixed socket outlet.

Wire the unit

Fit a suitable recessed back box

And run the cable through as shown.

Note:- The unit is supplied with a length of flexible

Cord for connecting to a suitably rated fused spur

if required).

Attach the installation panel to the wall

Using 4 of the screws provided.

If the wall is concrete, use

Commercially available metal screw plugs.

(Make sure that the wall the hand

Dryer is being fixed to is strong enough to

Take the weight of the dryer 9.5kg)

Remove the drain tank and air filter.

To gain access to the wiring terminals (If you do not wish

to use the fitted cord provided). Please proceed as

follows. Unscrew the 2 screws holding on the terminal box

cover located on the rear of the hand dryer. Loosen the 2

cable clamp screws, then disconnect the 3 terminal block

wires.

You can now carefully pull out the fitted cord.

To connect your own cord direct to the hand dryer please proceed as follows.

1. Raise the unit by approx 250mm from the floor (as shown).

2. Strip off the outer and inner insulation as shown below.

3. Connect the power cord to the terminal block as shown below.

4. Ensure the cable clamp is fitted and tight.

BC 2012 User Manual

Cable clamp