ACR Electronics AEROFIX 406 GPS I P-ELT - REV E Manuel d'assistance produit - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'assistance produit pour {nom_de_la_catégorie} ACR Electronics AEROFIX 406 GPS I P-ELT - REV E. ACR Electronics AEROFIX 406 GPS I P-ELT - REV E 14 pages. Personal locator beacon fcc type approval is currently pending
Également pour ACR Electronics AEROFIX 406 GPS I P-ELT - REV E : Manuel d'assistance produit (17 pages), Manuel d'assistance produit (17 pages), Manuel d'assistance produit (17 pages), Manuel d'assistance produit (17 pages), Manuel d'assistance produit (17 pages)

beacon tells Search and Rescue who you are, where you are, and that you are facing a life threatening

situation.

2.2

Self Test

PLEASE READ ALL INSTRUCTIONS BEFORE PERFORMING ANY OF THE TESTS.

Self test is initiated by holding the self test button (see figure 1) for more than half a second and less

than five seconds. Your beacon will sound an initial beep and green LED (Light Emitting Diode)

flash to signify the test has begun. A green LED will flash a second time to indicate that the self test

was successful.

Self tested components: Data Integrity and Memory; Check 406 MHz Synthesizer;

RF Power/Battery; Check GPS header

If your beacon flashes two LED's, the test has been successful. If you encounter only the initial

green LED flash alone, your beacon has failed the self test, please contact ACR Electronics or an

authorized Battery Replacement Center for servicing of your beacon.

2.2.1 Battery Witness Seal Life

ACR strongly recommend performing the self test on the TerraFix™ 406 GPS on a monthly basis.

If your beacon flashes an initial Red LED at the beginning of the Self Test, this indicates that your

electronic witness has been broken and you have used more than 1 hour of your battery life. While

the PLB will still operate normally in an emergency, ACR strongly recommends you have your

battery replaced and the electronic witness reset to ensure that you will have 24 hours of battery

power should you ever need to activate your unit.

NOTE: The homing beacon at 121.5 MHz is inhibited during self test.

Green & Red LED

GPS Interface

BE PREPARED TO RECORD DATA FROM THE TEST

Figure 1. Key pad Functions

Self Test Button

GPS Test Button

GPS I (P/N 2798.2)

GPS I/O (P/N 2798.4)

Off Button

Press together for

more than ½ of a

second to activate

the beacon in an

emergency

Y1-03-0174 Rev. A Draft