Cypress Semiconductor MoBL-USB CY7C68000A Fiche technique - Page 3

Parcourez en ligne ou téléchargez le pdf Fiche technique pour {nom_de_la_catégorie} Cypress Semiconductor MoBL-USB CY7C68000A. Cypress Semiconductor MoBL-USB CY7C68000A 16 pages. Tx2 usb 2.0 utmi transceiver

Imprimer la page

Operational Modes

The operational modes are controlled by the OpMode signals.

The OpMode signals are capable of inhibiting normal operation

of the transceiver and evoking special test modes. These modes

take effect immediately and take precedence over any pending

data operations. The transmission data rate when in OpMode

depends on the state of the XcvrSelect input.

OpMode[1:0]

Mode

Document #: 38-08052 Rev. *G

Description

Normal operation

Non-driving

Disable Bit Stuffing and NRZI

encoding

Reserved

Mode 0 enables the transceiver to operate with normal USB data

decoding and encoding.

Mode 1 enables the transceiver logic to support a soft disconnect

feature that tri-states both the HS and FS transmitters, and

removes any termination from the USB, making it appear to an

upstream port that the device is disconnected from the bus.

Mode 2 disables Bit Stuff and NRZI encoding logic so '1's loaded

from the data bus becomes 'J's on the DPLUS/DMINUS lines

and '0's become 'K's.

DPLUS/DMINUS Impedance Termination

The CY7C68000A does not require external resistors for USB

data line impedance termination or an external pull up resistor on

the DPLUS line. These resistors are incorporated into the part.

They are factory trimmed to meet the requirements of USB 2.0.

Incorporating these resistors also reduces the pin count on the

part.

CY7C68000A

Page 3 of 15

[+] Feedback