Cyrus DAC X Instructions pour l'utilisateur - Page 6
Parcourez en ligne ou téléchargez le pdf Instructions pour l'utilisateur pour {nom_de_la_catégorie} Cyrus DAC X. Cyrus DAC X 7 pages.
Imprimer la page
Cyrus DAC X
TROUBLESHOOTING GUIDE
If your DAC X is not operating properly, disconnect the power and carefully
check all connections and the set-up procedure using the notes in this
handbook. If problems persist, the checklists below may help.
If you are in any doubt, consult your dealer.
No sound from any speaker with any source
Amplifier not switched on.
Outputs to amplifier not correctly
connected.
No sound from one source
Incorrect source selected.
Input named incorrectly.
Pause may have been set.
Invalid audio format.
Input not correctly connected.
Loud noises from the speakers with certain sources or discs
Invalid audio format.
No sound from one loudspeaker
Balance control at extreme limit.
Does your speaker have fuses?
Amplifier faulty.
If a fault condition still remains, return the DAC X (together with the PSX-R if
you are using one) to your Cyrus appointed dealer or an authorised Service
Centre.
4
Switch on the system amplifier(s).
Switch off the power to the audio
system and check that connections
have been correctly made from the
source to the DAC X and from the
DAC X to the system amplifier(s) and
speakers.
Check source selection.
Check that the input is correctly
named.
Check the source.
Check the audio format of the
disc/tape to ensure it is compatible
with the DAC X.
Switch off the power to the audio
system and check that connections
have been correctly made from the
source to the DAC X.
Check the audio format of the
disc/tape to ensure it is compatible
with the DAC X.
Centralise the amplifier Balance
control.
Check speaker, replace fuses.
The amplifier can be tested by
exchanging left and right output
channels from the DAC X. Switch off
the power to the audio system before
making
any
changes
to
connections.
WARRANTY
The warranty card enclosed should be completed by the Dealer and
the purchaser and returned to CYRUS or its Distributor within 8 days
of purchase. No Dealer or Distributor may vary the terms of this
warranty which is personal to the original Purchaser and is not
transferable.
Please retain the sales receipt as proof of purchase.
Warranty claims must wherever possible be made through the Dealer
from whom the equipment was purchased.
This warranty excludes:
•
Damage caused through neglect, accident, misuse, wear and
tear, or through incorrect installation, adjustment or repair by
unauthorised personnel. Any unauthorised servicing will result in
loss of guarantee.
•
Liability for damage or loss occurring in transit to or from the
purchaser.
•
Consequential damage, loss or injury, arising from or in
conjunction with this equipment.
Equipment for attention under warranty should be consigned return
carriage paid. If returned equipment is found to comply with the
published specification, CYRUS reserves the right to raise a charge.
The above conditions do not affect your statutory rights as a
consumer.
Specifications
Power Supply
Voltage: .......................................................................... As plate on rear of unit
Power consumption (Standby) .................................................................... 12W
Power consumption (Operational)............................................................... 14W
EMC & Safety Compliance (230V).................................................................CE
EMC & Safety Compliance (115V)............................................... FCC, cCSAus
Enclosure
Dimensions (WxHxD)............................................................ 215 x 75 x 365mm
the
Weight ....................................................................................................... 3.8Kg
Material......................................................................................Die cast chassis
Audio Performance
Inputs
Input voltage...................................................................................500mV pk-pk
Input Impedance ......................................................................................... 75Ω
S/N ratio, (PCM in, 0dBFS) .................................................................... 115dBA
THD+N, (PCM in, 0dBFS).......................................................................0.002%
Outputs
Output voltage (dig. in, vol max) .......Fixed out........................................... 2.3V
Output Impedance.............................Fixed out........................................... 47Ω
User Instructions
Balanced out .................................... 4.6V
Balanced out .................................... 47Ω
GB
GB