Cyrusher RANGER Manuel du propriétaire - Page 14
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Cyrusher RANGER. Cyrusher RANGER 16 pages. All-terrain e-bike
Imprimer la page
Trouble shooting
Error Codes
E001
Open Throttle Fault
E005
Throttle Fault
E006
Low Voltage Protection
E007
Over Voltage Protection
E008
Motor Hall Signal Fault
E009
Motor Phase Line Fault
E010
High Temperature Fault
Motor High Temperature
E011
Protection
E012
Current Sensor Fault
Motor Temperature Sensor
E014
Fault
Controller Temperature
E015
Sensor Fault
E021
Motor Speed Sensor Fault
E025
Torque Signal Fault
E026
Speed Signal Fault
E030
Communication Fault
OWNERS MANUAL | CYRUSHER RANGER
Throttle has not returned to the start position on start-up. Check to see if the throttle can
return to the start position or if there is something blocking the throttle unit.
Throttle may be damaged. Check the throttle or throttle cable for damage.
The battery voltage is too low to operate. Incorrect battery was used on the bike. The
battery is in sleep mode or not functioning correctly.
The battery voltage is too high to operate. Incorrect battery was used on the bike.
Check to be sure that the correct battery is being used on the bike
At least one of the motor's hall sensor wires have been disconnected or damaged.
Disconnect and reconnect the motor cable.
At least one of the motor's phase wires has been disconnected or damaged. Or phase
line connector fault.
The controller has reached the highest allowable temperature.
Allow the controller to cool down before using the e-bike again.
Allow the motor to cool down and check if it recovers.
The controller's current sensor has become disconnected or damaged. Contact
technical support.
The motor temperature sensor fault. Contact technical support.
The controller temperature sensor fault. Contact technical support.
The motor speed sensor has become disconnected or damaged. Check if motor cable
loose. Disconnect and re-connect the cable. If doesn't recover, contact technical
support.
Torque sensor –torque signal fault. Contact technical support.
Torque sensor –speed signal fault. Contact technical support.
Poor connection between the controller and the display. Check all cable connectors.
Check for corrosion damage.
14