BLUEREV CANADIAN Manuel de l'utilisateur - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} BLUEREV CANADIAN. BLUEREV CANADIAN 16 pages.

Imprimer la page

SW900 COMPUTER DISPLAY

DISPLAY CONTROLS: Three buttons on the handlebar control display

1. Up arrow

2. M (multi-function center button): long hold will turn on the E-Bike

3. Down arrow

Press Up Arrow to activate lights.

Press Up and Down arrows together to enter Program Modes:

P01 - LCD display Brightness (15 levels)

P02 - Units in Miles or Kilometers - 0 is Kilometers; 1 is Miles.

P03 - Voltage of battery and motor that you are using, 48V is default.

P04 - Sleep time on display, choose between 0 and 60 minute. (0 means no sleep time)

P05 -Pedal Assist Mode, 0 is for three grades of pedal; 1 is for five grades of pedal assist.five

assist modes has a higher sensitivity to your pedal inputs versus the work outputs.

P06 - Wheel size, in this case set to 24" for Trio, important to correctly track speed and mileage.

P07 - Speed measuring magnet, ranges from 1 to 100. For the Trio it is set at factory for 500 watt

motor, do not change this.

P08 - Speed limit. Important depending on where you live, to adhere to local e-bike bylaws.

Europe - 15mph; USA - 28mph; Canada - 20mph (33kph). Speed can be set from 0-100, so

maximum speed can be achieved, but observe local regulations is recommended.

P09 - Zero start, or Non-zero start. 0 setting is immediate response from throttle. 1 setting is

delayed reaction from throttle.

P10 - Driving mode which determines which PAS. Three settings: 0, 1, 2. 0 is driven by the PAS

with no throttle available. 1 is driven completely by the throttle and there are no PAS. 2 is a

combination of both pedal assist (PAS) and throttle.

P11 - Pedal Assist sensitivity in a range from 1 to 24. 24 (the highest) means you will get the most

out of pedal assist which in turns gives you the best range and efficiency out of the motor

(less effort on motor) and battery.

P12 - Pedal assist start strength, how quickly the pedal assist kicks in. Range is 0 to 5. 5 means

the pedal assist immediately starts when you turn the pedals.

P13 - PAS Magnet. Three different settings, 5, 8 and 12. 5 is default, you can leave it at the

default setting that is setwith your bike.

P14 - This is the amperage setting for your convtroller, settings between 1 to 20 amps. You may

want to set this to the battery amperage. The stock battery is 13Ah so leave it set at 13. If

you upgrade the battery you have a maximum of up to a 20Ah battery.

P15 - Factory setting and cannot be changed.

functions, and turn on/off the e-bike controller.

1. Battery level - Displayed in blocks of five.

2. Odometer - Total mileage driven on the vehicle.

3. Speed - Current operating speed.

4. Current Power Mode (Eco, Standard, Power), depending on PAS

5. Pedal Assist Level (1 through 5) - the amount of assist you will

receive, the

greater the number, the greater the assist.

6. Current power in watts - pay attention to this so you don't run

MOTO-81 Turbo Dual Motor ONLY

I = Front Motor Only

II = Front and Rear Motors

III = Rear Motor Only

U S E R M A N U A L