EGAmaster 79991 Manuel d'instructions - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} EGAmaster 79991. EGAmaster 79991 18 pages. Torque wrenches

1. The wrench is reversible, allowing tightening in both directions, but is only calibrated for

clockwise tightening.

2. Examine wrench for cracks, scratches, rust, or other damages. These can cause wrench

failure and operator injury.

3. Any defect found in insulating layer of wrench, NO LIVING WORK allowed, please send

wrench to do performance check or maintenance.

4. Do not drop the wrench when working at a high position, drop will damage the wrench, and

result in inaccuracy.

5. Make sure the ratchet in the correct position.

6. Never extend the handle length, it will cause inaccuracy of wrench.

7. Make sure the wrench is operated by qualified staff.

8. Do use with an insulated glove when operating.

1. To unlock pull the lock collar toward the hand grip section and hold

in position while turning the grip.

2. Turn the grip to righ until reach the torque setting.

Example: setting 16NM.

3. Turn the grip to the right until zero aligns with the scale centerline

and the end of the grip aligns with the 15 torque setting.

4. Continue to turn the grip to the right until 1.0 aligns with the scale

centerline.

5. Release the lock collar and turn the grip slightly left or right until

the lock collar springs forward into the lock position to ensure exact

alignment is achieved.

WARNINGS