Asko D1996SS Manuel d'utilisation et d'entretien - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Asko D1996SS. Asko D1996SS 12 pages. Standard dishwashers
Également pour Asko D1996SS : Manuel d'utilisation et d'entretien (12 pages), Installation et personnalisation (4 pages), Manuel de planification et de conception (19 pages), Manuel de planification et de conception (15 pages)

Imprimer la page

ADJUSTING THE AMOUNT OF RINSE AID DISPENSED

A measured amount of rinse aid is released during the

final rinse. As with detergent, the amount of rinse aid

needed for your dishes depends on the hardness of the

water in your area. (See page 5.) Too much rinse aid

can result in lather or foaming and cause cloudiness or

streaks on your dishes. If the water in your area is very

soft, you may not need rinse aid. If you do, you can dilute

the rinse aid with an equal amount of water.

Rinse aid

adjustment dial

WHEN TO REFILL THE RINSE AID DISPENSER

The black dot on the rinse aid dispenser indicates the

amount of rinse aid in the dispenser. As the rinse aid

diminishes, the size of the black dot decreases. You

should never let the rinse aid get below 1/4 full.

Rinse Aid Level Indicator

RINSE AID INDICA

RINSE

AID INDICAT T OR LIGHT

Models D1996, D1976, and D1976CUS have a rinse

aid indicator light on the control panel that comes on

when the dispenser is empty. After you refill the

dispenser, there may be some delay before this light

goes out.

CARE AND CLEANING

The interior of your ASKO dishwasher is made of

surgical quality stainless steel that has been electro-

polished to make it the smoothest surface available.

The smooth surface prohibits the accumulation of dirt

and bacteria inside the unit. If the water in your area is

especially hard, however, lime deposits could form

FILTERING SY

FIL

TERING SYSTEM

STEM

For your convenience, we have placed the drain pump

and filtering system within easy reach inside the tub.

There are three components of the filtering system: the

main filter, the coarse filter, and the fine filter.

Main filter

Food and soil particles trapped

by this filter are pulverized by a

special jet on the lower spray

arm and washed down the

drain.

WARNING!

Page 6

OR LIGHT

Never run the dishwasher without the filters in place.

The rinse aid dispenser has six settings. Always start

with the dispenser set on "1." If spots and poor drying

are problems, increase the amount of rinse aid

dispensed by removing the dispenser lid and rotating

the dial to "2." If the dishes still aren't drying properly or

are spotted, adjust the dial to the next higher number

until your dishes are spot-free.

To increase the amount of rinse aid released

in the final rinse, turn the adjustment dial to

the next higher number.

NOTE

Only adjust the dial one number at a time.

As the rinse aid diminishes, the size of the

black dot on the rinse aid level indicator

changes, as illustrated below.

Full

3/4 full

1/2 full

1/4 full - Should refill to eliminate spotting

Empty

Some models have a rinse aid indicator

light on the control panel that lights up

when the dispenser is almost empty.

inside the machine. If this happens, you can remove

them by putting two tablespoons of citric acid in the

detergent compartment and running a Normal

program. In extremely hard water areas you may need

to repeat this process a few times to remove hard water

deposits.

Coarse filter

Larger items, such as pieces of bone or

glass, that could clog the drain are

trapped in the coarse filter. To remove

an item caught in this filter, gently

squeeze the tabs on top of this filter

and lift it out.

Fine filter

This filter holds soil and food

residue in the sump area and

prevents it from being

redeposited on the dishes

during a cycle.