Bluerock Tools 40A Manuel opérationnel - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel opérationnel pour {nom_de_la_catégorie} Bluerock Tools 40A. Bluerock Tools 40A 13 pages. Grinder/sander/polisher

Imprimer la page
4 0 A
G R I N D E R / S A N D E R / P O L I S H E R
1)
Main Rubber Drive
2)
Secondary Drive Wheels
3)
Abrasive Side of Belt
4)
Non-Abrasive Side of Belt
5)
Spring Arm
6)
Plastic Guard

TRANSPORTING THE MACHINE

Ø
When transporting the machine, always carry with both handles.
Ø
If transporting inside a vehicle, it is recommended to transport it on its side so as to avoid the item falling
over.
Ø
DO NOT carry the machine by the cord.
Ø
DO NOT allow the cord or plug to drag along the floor when transporting.

RUNNING THE MACHINE

Ø
Do all pre-operational and operational safety checks from Chapter 1.
Ø
Consider your security and stability as well as the orientation of the machine in the work area.
o
Ø
Ensure the secondary handle is securely attached.
o
Ø
Ensure the work surface is free of debris, oil, etc.
Ø
Select appropriate grit sanding paper. Install paper.
o
Ø
Select rotational speed 1-6 using speed chart below (meters per second):
Ø
Plug the machine into power source.
Ø
Turn the machine on.
o
o
Ø
Very slowly engage the sanding paper with the material surface by lightly engaging towards the material.
Ensure the sanding belt is parallel to the work surface. Operating at right angles will ensure the belt does
not fall off the rollers.
o
Consider the work surface material, condition, strength, density and rigidity. These factors
directly affect the tools operation and user safety.
It can be connected from the right or left side.
Note: See section below for more information on paper installation.
o 1
o 2.7 m/s
o 2
o 3.8 m/s
o 3
o 5.1 m/s
Start the machine by sliding switch 1 in picture below forward. For continuous operation, tilt
switch downwards until it engages. Stop the machine by sliding the switch backwards and
release.
NOTE: Do not force the sanding. Let the machine do most of the work. Excessive physical effort
should be avoided as it can cause damage to the machine or the user.
7)
Secondary Handle
8)
Lock for Main Rubber Drive
9)
Main Handle
10)
On/Off Switch
11)
Variable Speed Switch
o 4
o 6.3 m/s
o 5
o 7.6 m/s
o 6
o 8.5 m/s
5