Bluerock Tools CG-30 Manuel opérationnel - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel opérationnel pour {nom_de_la_catégorie} Bluerock Tools CG-30. Bluerock Tools CG-30 18 pages. Track torch / burner machine

Imprimer la page

C G - 3 0

T R A C K

T O R C H

Operations

DO NOT attempt to use this machine unless you are trained in its proper use as

well as trained in the proper use of gas cutting equipment. THOROUGHLY READ

THROUGH THE ENTIRE MANUAL BEFORE OPERATING THIS MACHINE!

PURPOSE

Ø The purpose of the CG-30 is to cut steel using oxy-acetylene or propane gas flame cutting. The

machine is designed to cut straight and bevel cuts. The torch holder can be adjusted ±15

Ø These machines are designed to run along v-frame cutting tracks. This machines comes stock

with 2 pcs of 6' track (12' total), but additional track can be used to cut longer runs.

Ø This machine is designed to make horizontal cuts.

OPERATIONAL PRINCIPLES

Ø When placed on the cutting tracks, the main machine wheels rotate in a forward or reverse

direction. When engaged, the flame cuts into the steel. The machine speed can be increased or

decreased using the variable speed switch. Using the adjusting knobs on the machine, the user

can raise or lower the torch holder.

MACHINE COMPONENTS

Ø The main components of the CG-30 are the large torch bracket assembly, torch holder, motor,

electrical control panel, machine body and main spreader bar.

Ø This machine has two primary adjusting knobs to position the torch holder.

B U R N E R

M A C H I N E

WARNING: THE CG-30 is not designed to detect the end of the cutting track. Be careful

not leave the machine cutting unattended as it may fall from the end of the elevated work

piece.

The electrical components must be not be removed except by a qualified technician.

Power must be disconnected prior to any service.

These knobs are both located on the large torch bracket assembly (see figure below).

The top knob will adjust the torch holder left to right.

WARNING

Chapter