d&b audiotechnik 4S/5S Manuel - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} d&b audiotechnik 4S/5S. d&b audiotechnik 4S/5S 12 pages.

-5

-10

-15

-20

-25

-30

100

Fig. 6: Frequency response correction of HFA circuit

d&b 4S/5S Manual (1.1 EN)

10k

20k

2.3. Operation

NOTICE!

Only operate d&b loudspeakers with a correctly configured d&b

amplifier, otherwise there is a risk of damaging the loudspeaker

components.

Operation with D6 or D12

Select the controller setup 4S for 4S loudspeakers.

Select the controller setup 5S for 5S loudspeakers.

Within the D12 amplifier they are available in "Dual Channel" or

"Mix TOP/SUB" mode. For combinations with active subwoofers

fed by a single 4-wire cable "Mix TOP/SUB" mode must be

selected.

Up to a total of four 4S or 5S loudspeakers can be driven by each

channel of the D6 or D12 amplifiers.

For acoustic adjustment the functions CUT, HFA and CPL can be

selected.

CUT circuit

Set to CUT, the cabinet low frequency level is reduced. The

cabinets are now configured for use with d&b active subwoofers.

HFA circuit

In HFA mode (High Frequency Attenuation), the HF response of the

system is rolled off. HFA provides a natural, balanced frequency

response when a unit is placed close to listeners in near field or

delay use.

High Frequency Attenuation begins gradually at 1 kHz, dropping

by approximately 3 dB at 10 kHz. This roll off mimics the decline

in frequency response experienced when listening to a system from

a distance in a typically reverberant room or auditorium.