d&b audiotechnik Z Series Instructions de montage - Page 6

Parcourez en ligne ou téléchargez le pdf Instructions de montage pour {nom_de_la_catégorie} d&b audiotechnik Z Series. d&b audiotechnik Z Series 12 pages. Al flying adapter
Également pour d&b audiotechnik Z Series : Instructions de montage (14 pages), Instructions de montage (8 pages), Instructions de montage (7 pages), Instructions de montage (11 pages), Manuel de gréement (18 pages), Instructions de montage (10 pages)

Imprimer la page
6
Option 2
The bracket is attached to the cabinet with hole [a] facing to the
back of the cabinet. One bolt is fitted into hole [a] and the second
one is fitted into the axis of slot [b] and slot [c] to allow the bolt to
move in slot [c].
The vertical coverage angle can be set over a range of 60°,
starting from –30° to –90°.
Option 3
The bracket is attached to the cabinet with hole [a] facing to the
back of the cabinet. Both bolts are fitted into slot [b].
The vertical coverage angle can be set over a range of 11°,
starting from 0° to +11°.

1.5 Assembly

Attaching the bracket to walls or ceilings
NOTICE!
Only use mounting parts (fixing anchors and screws) that are
suitable for the intended application.
Observe the occurring extraction forces acting on the fixing
anchors and screws. The rated extraction forces for the respective
application (wall or ceiling mounting) and cabinet are listed in the
following table.
Application
Wall mounting
Ceiling mounting
To attach the bracket to walls or ceilings, use the holes shown in
the graphic opposite to provide adequate support.
A corresponding fixing template is supplied with these mounting
instructions. Refer to Þ Chapter 2 "Fixing template" on page 8.
Rated extraction forces
560 N
380 N
d&b Z5388 Mounting instructions 1.2 en