Asko DW955 Manuel d'utilisation - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Asko DW955. Asko DW955 17 pages. Asko 1905: user guide

Too little water in the machine?

The water level is correct when it reaches up to the marking of the lower

spray pipe bearing, see picture.

If there is insufficient water in the machine, it may be because the supply pressure

is too low. This can be compensated for by altering the admission time.

1. Press

five times within 15 seconds to get into the water level modification

programme.

2. Press

to get the normal inlet time

to get 25 % increase

to get 50 % increase

to get 100 % increase

to get 150 % increase

to get 200 % increase

How to set the pumping out time

If you have a longer outlet hose or if there by other reason is a too short time for the

machine to pump out the water, the pumping-out time can be changed. Do like this:

1. Press

5 times within 15 seconds. Then you get into the changing programme.

2. Press

to get an outlet time of

Press

The display window...

The displaywindow has four functions. It can show the temperature, the fault indication, the remaining

programme time and the re-programming.

...shows how much programme time remains

When a programme starts, the display shows the length of time it took when it was last run. As the

programme proceeds, the display counts down, showing the time remaining. Times can vary slightly

from one time to another, due tovariations in the incoming water temperature etc.

As the time proceeds, the time is counted down and the estimated time remaining is displayed . If the

time exceeds 60 minutes, the display alternates between the number of hours, followed by h, and the

number of minutes: e.g. 1h–25–1h–25, which says that 1 hour and 25 minutes remain of the

programme.

20 seconds

Normal time

Display shows