Asko XXL Series Manuel d'instructions d'installation - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Asko XXL Series. Asko XXL Series 20 pages.

Imprimer la page

STEP 4. CONNECTING ELECTRICITY, WATER, AND DRAIN

2. CONNECT WATER SUPPLY HOSE

WARNING!

Plumbing connections must comply with

applicable sanitary, safety and plumbing codes

in your area.

The machine can be connected to either a hot

(max. 160 °F, 70 °C) or cold water supply. We

recommend a cold water supply. The water

pressure should be 4.2-140 psi.

Connect to cold water...

If you use oil or electricity to heat your home.

Connect to hot water (max 160 °F, 70 °C)...

If you use district heating, solar power, or

geothermal power to heat your home. Choosing

a hot water connection cuts program times and

reduces the dishwasher's electricity consumption.

For service convenience, a shut-off valve (not

supplied) should be installed in the supply line in

an easily accessible location, such as, beneath

the sink.

In order to prevent heat damage to the inlet valve,

all solder connections must be made before the

water supply line is connected.

Flush the water supply line prior to connecting it

to the water fill tube.

The unit has a float switch in the base pan to protect

against flooding. If the inlet valve connection is not

seated properly, water may leak into the base pan

and activate the float switch.

Water connection should be carried out by a

qualified professional. It is important that the water

supply line and the shut-off valve have a sufficient

flow volume. At least 3 gallons (12 liters) per minute

must be able to pass through the line. Connect the

machine using the accompanying supply hose.

Water pressure should be 4.2-140 PSI. There

should be a shut off valve on the water pipe.

Use the supplied O ring and tighten the connection

by hand plus a quarter turn with a wrench.

If the pipes are newly installed, it may be wise

to flush them so that any debris is washed

away. Otherwise, debris can clog the filter in the

machine's water intake and cut off the water supply.

Only use the inlet hose supplied with the machine.

Do not reuse old or other loose inlet hoses.

CUSTOMER CARE CENTER 1-800-898-1879 • WWW.ASKONA.COM

Shutoff

valve

Grounded

outlet

(1) Water supply

(2) Water supply valve (not supplied)

NOTE:

Be sure to run the PEX tubing through the hole leading

to the sink compartment before moving the dishwasher

into position.

Water connection

(1)

(2)