Ambient EZ2-35W2MC Manuel de démarrage rapide - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Ambient EZ2-35W2MC. Ambient EZ2-35W2MC 2 pages. Pole mounting kit
Imprimer la page
Tools and Materials Needed
•
Adjustable Wrench
•
Level or Plumb
•
Drill
Important Installation Instructions
CAUTION: Any metal object may attract a
lightning strike, including your weather station
and tripod.
Never install your weather station in a
thunderstorm.
We recommend properly grounding the tripod to
avoid extensive damage to the weather station
and structure. Consult a licensed electrician or
local lightning detection expert prior to installing
a ground wire.
Mounting Pole Installation
1. In a fence post or other flat vertical
surface, drill two holes, using one of the
1-1/8" saddles as a guide.
2. Drill another set of holes at least 12"
away from the first holes.
3. Using the lag screws, secure the saddles
and into the post.
4. Tighten the lag screws until the
complete mast assembly will not slide
up or down, if you received
Configuration 1 see step 6 below.
5. Insert the swaged end of the support
tube in the open top of the extension
tube.
Ambient Weather
6845 W. Frye Road
Chandler, AZ 85226
TEL 480-346-3380 l FAX 480-346-3381
www.AmbientWeather.com
6. Reference Figure 3 above. Insert one of
the swaged ends into a smooth end and
tighten, by applying rotational force
(hand tight is usually enough), so the
extension does not rotate loose when
permanently installed.
Repeat this step for the second, third,
fourth, fifth and sixth 14" mast. The
entirely smooth 14" mast should be on
the bottom of the assembly.
Page 2
Figure 3