Ambirad Vision VSO Series Panduan Perakitan & Instruksi - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Perakitan & Instruksi untuk Pemanas Ambirad Vision VSO Series. Ambirad Vision VSO Series 20 halaman. Radiant tube heaters

Halaman Cetak

Introduction.

Welcome to the new range of high efficiency

AmbiRad Vision radiant tube heaters. Local

regulations may vary in the country of use and

it is the installers responsibility to ensure that

such regulations are satisfied.

All installation, assembly, commissioning and

service procedures must be carried out by

suitably qualified and competent persons to the

statutory regulations in the country of use.

When assembling, installing, commissioning

and servicing is undertaken on radiant tube

heaters specified in these instructions, due care

Document Index.

1 Installation Requirements

1.1 Health & Safety

1.2 Model definitions

2 Assembly Instructions

2.1 Tools Required

2.2 Assembly Notes

2.2.1 Tubes

2.2.2 Turbulators

2.2.3 Brackets

2.2.4 Couplers

2.2.5 U Bend

2.2.6 Reflectors

1. Installation Requirements.

Isolate any electrical supply to the

heater and controller before proceeding.

1.1

Health and Safety

AmbiRad

heaters

accordance with the relevant provisions of the

Gas Safety (Installations and Use) Regulations

1998. Due account should also be taken of any

obligations arising from the Health and Safety

at Works Act 1974 or relevant codes of

practice. In addition the installation must be

carried out in accordance with the current IEE

wiring

regulations

(Industrial & Commercial) and any other

relevant British Standards and Codes of

Practice by a qualified installer. Isolate all

electrical supplies to the heater & controller

before proceeding.

For your own safety we recommend the use of

safety boots and leather faced gloves when

must

installed

(BS

7671),

6896

and attention is required to ensure that working

at height regulations are adhered to at the

mounting heights specified.

PLEASE READ this document prior to

installation to familiarise yourself with the

components and tools you require at the various

stages of assembly.

All Dimensions shown are in mm unless

otherwise stated.

The manufacturer reserves the right to alter

specifications without prior notice.

2.2.7 End Caps

2.2.8 Burner Assembly

2.2.9 Heat Exchanger Assembly

2.2.10 HB Damper Assembly

2.2.11 End Moulding Fixing

2.2.12 HB Damper Assembly

2.2.13 Detailed Assembly Drawings

3 User and Operating Instructions

3.1 To Start Heater

3.2 To Switch off Heater

3.3 Routine Maintenance Between Service Intervals

3.4 Frequency of Servicing

handling sharp or heavy items. The use of

protective eye wear is also recommended.

1.2

Model Definitions

VSOUT

= AmbiRad Vision U Tube Unitary

heater with painted induced burner, ID Fan,

aluminised

steel

insulation, tube over shields, painted canopies

and optional end covers.

VSOUH

Herringbone heater with painted induced burner,

Damper, aluminised steel reflectors, end caps,

insulation, tube over shields, painted canopies

and optional end covers.

VSXO

= AmbiRad Vision High efficiency U

Tube heater with forced burner, recuperative

heat exchanger, aluminised steel reflectors, end

caps, insulation, tube over shields, painted

canopies and optional end covers.

reflectors,

end

AmbiRad

Vision

Doc No. 700021 Page 2 of 20

caps,

Tube