Ambirad VISION COMPACT Series Panduan Pengoperasian, Pemeliharaan, dan Servis - Halaman 19

Jelajahi secara online atau unduh pdf Panduan Pengoperasian, Pemeliharaan, dan Servis untuk Pemanas Gas Ambirad VISION COMPACT Series. Ambirad VISION COMPACT Series 19 halaman. Gas fired radiant tube heaters

Halaman Cetak

19 User instructions for Ambi-Rad Vision Compact series of heaters

Vision Compact is an overhead radiant heating system for industrial and commercial buildings. The Vision Compact heater is suspended

horizontally overhead from the roof or inclined mounted at 30˚ to 45˚ from the horizontal and heats by radiation in the same way as the sun.

20 Important Information

1. This appliance must only be installed by a competent person in accordance with the requirements of the Codes of Practice or the rules in

force.

2. Warning this appliance must be earthed.

3. Never rest anything, especially ladders, against the heater.

To start the Vison Compact heater

1. First ensure that the gas supply to the heater is turned on.

2. Ensure that the settings of any time-switch and thermostat are such that the heating system will be required to operate.

3. Switch on electrical supply to heater. Mains light, coloured red will illuminate and ignition sequence will commence.

4. After completion of an air purge period, ignition of the burner will occur and burner light, amber, will illuminate.

5. If lock out occurs, switch off electrical supply, wait 15 seconds then switch on again. If lock out occurs again switch off heater and call

out a service engineer.

Note U bend will glow, but this is acceptable.

To switch off Vision Compact heater

1. Switch off electrical supply to the heater. The burner will shut off and the fan will stop.

2. If the heater is switched off for periods in excess of one week, it is highly recommended that both gas and electrical supplies are turned

off.

Servicing

To ensure continued efficient and safe operation it is recommended that the heater is serviced regularly by a competent person e.g. every

year in normal working conditions but in exceptionally dust or polluted conditions more frequent servicing may be required. The

manufacturer, whose address is given below, offers a maintenance service. Details available on request.

The data plate (supplied) should be attached on, or adjacent to a low level user control, as it contains the instructions for the safe operation

of the appliance including its lighting and shut-down procedures.

Ambi-Rad Limited Fens Pool Avenue

Brierley Hill West Midlands

Telephone 01384 489700

Facsimile 01384 489707

UK sales email sales

Website www.ambirad.co.uk

5 1

United Kingdom

ambirad.co.uk

is the registered

trademark of Ambi-Rad Limited.

Due to continuous product

innovation, Ambi-Rad reserves

the right to change product

specification without due notice.

Document reference number : GB/COB/112/0905