Aero BLACK Series Petunjuk Penyiapan - Halaman 5

Jelajahi secara online atau unduh pdf Petunjuk Penyiapan untuk Kendaraan Utilitas Aero BLACK Series. Aero BLACK Series 12 halaman.

Place the valves as shown and connect them with blue pipe. Use the

smaller size of jubilee clips to secure.

Use green 16mm pipe to install the reducing tees in line with the lid

clip and attach pieces of 4mm pipe through the slot in the lid clip.

Fit lengths of the 4mm pink pipe to the reducing tee's, push the

other end through the grommet so 4cm of pipe is showing. This will

avoid water splashing between the pot and lid and also hit the net

pot in the correct place. (We recommend running the system for 60

seconds without the sprinklers to remove any debris present in the

pipes). Push-fit the sprinklers when ready. Blue 90° sprinklers are

used on the 15L pots.

The green 16mm pipe runs the length of the system from the valves

to the last pot. Fit 16mm blanks at the end of each line.

CAMO

Tank

Assemble the tank using the leaflet provided. The tank can be

located inside or outside of the grow room. If located outside,

depending on distance, more pipe may be required.

RAIN™ Pump

Fit the blue pipe to the RAIN™ pump and secure with a Jubilee clip.

4 - 18 pot systems use 25mm pipe. 21 pot systems upwards use

26a

40mm pipe. The pump sizes are shown here.

26b

Place the RAIN™ pump at the bottom of the tank and fit the

25mm/40mm siphon tee as shown just underneath the lid. Put a

piece of pipe through the hole in the tank lid and fit 2 x elbows.

Use hose clips to secure all connections on the blue feed line.

The drain siphon tee is 19mm and is connected in the same way

but without clips. Black 19mm elbows and pipe are used here.

Connect the blue feed line and black drain line to the fittings on the

header. Secure feed line with clips.

Secure the RAIN™ Brain to a wall, away from possible water contact.

Connections to "Power" and "RAIN™ pump" are shown.

Connect the cable from the red drain pump in the header pot to the

ALIEN

adaptor by pushing the connector in and securing the lock

nut. You may have a different style of adaptor than the one shown.

This should remain powered 24/7. Whenever the pump senses

water it will engage and drain the header.