AMC SRL400/R Panduan Pemasang - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pemasang untuk Sensor Keamanan AMC SRL400/R. AMC SRL400/R 6 halaman. Two-way radio buzzer kit for r400 series control units
Halaman CetakASSEMBLY DIAGRAM OF THE TRANSMITTER MODULE FOR THE R400
- Insert the plstic turrets in the relevant holes
- insert the board in the turrets and thread the antenna connector in the hole
- insert thespacer O-ring in the connector and screw the antenna
- insert the FLAT cable in the connectors, respectively in control unit (r400) and on the mini-board (see fig.)
PROGRAMMING AND LEARNING
Device programming is of self-learing type and takes place in two-way mode in just one operation:
- Power both the devices
- Hold the key on the SRL400 buzzer pressed until the green LED of the board flashes slowly.
- Hold the key on the SRL400 transmitter pressed until the green LED of the board flashes slowly.
- Hold the key on the CSR400 or on the SRL400 pressed shortly.
- If the programming sequence is not successful, both LED (on the SRL400 and on the CSR400 buzzer) will stop flashing slowly.
To check that the 2 objects are properly programmed, press the key on the CSR400 and check the BEEP on the SRL400 buzzer.
Conversely, by pressing the key on buzzer, the green LED will flash fast from 1 to 3 times.
Note: the combination between CSR400 and SRL400 is unique.
www.amcelettronica.com
SRL400/R V1.0 EN