Amca MiKD-350-S Panduan Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Medis Amca MiKD-350-S. Amca MiKD-350-S 20 halaman. Hand-desinfectiontower with fiebermessfunktion

Halaman Cetak

1.1.11. The appliance must be connected to an earthed socket.

1.1.12. Never use the appliance if the power cord or device is dama

1.1.13. Do not use this device with an extension cable.

1.1.14. Make sure that the device and all its parts are dry before connecting to

power supply and asse mbling its parts.

1.1.15. Never tauch the device or its power plug when your hands are wet.

1.1.16. Position the device so that the power plug is always accessible.

1.1.17. To avoid damaging the power

rubbed against sharp

and naked

flames.

1.1.18. Ensure that there is no risk of accidentally disconnecting the power cord or

of stumbling while using the

1.1.19. Unplug the device after use or when leaving the room where the device is

located or in the event of

1.1.20. Always unplug the device before cleaning. Never clean the device during operation.

1.1 .21. Do not pull the cord to disconnect the appliance from the power supply

and do not wrap the cable around the device.

1.1.22. The device must not suffer a pow er

1.1.23. The operating voltage of the device is 220-240

1.1.24. The system must be vented during the initial start-up to allow the

disinfectant to flow out.

1.1.25. Never use the appliance in or near flammable or combustible

environments and substances.

1.1.26. The ambient temperature needs to be between 10 - 43

colder environments is not recommended for efficiency.

1.1.27. Leave enough free space behind the device to add disinfectant.

1.1.28. lf two devices are placed next to each other, there should be a distance of

at least 50 cm betwe en them.

1.1.29. The device must operate and stop smoothly. Make sure the device stands

stable on a horizontal and solid ground. This should be done before

putting disinfectant.

1.1.30. Before you start using your device drain

possible dust during transportation. In this way you will disinfect your device.

1.1.31. Never pul it into operation if there is no disinfectant in its storage.

1.1.32. When using the

disinfectant is completely used up. This is necessary to ensure that the

disinfectant settings in the product are not disturbed.

cord,

edges.

Keep the power cord away from hat surfaces

appliance.

malfunction.

product,

do not add any disinfectant before the existing

prevent it from being crushed,

failure.

V~,

50 Hz.

·c.

litres of disinfectant against

ged.

bent,

Operation in