FLO-DYNAMICS VacFill3 Manual - Halaman 16

Jelajahi secara online atau unduh pdf Manual untuk Peralatan Servis FLO-DYNAMICS VacFill3. FLO-DYNAMICS VacFill3 20 halaman.

10. Insert Cone Adapter into radiator, making sure the tip of the cone is submerged.

HINT: If servicing from bottle, insert a hose into the cone long enough to reach

near the bottom of the bottle (hose not supplied).

11. Wait until no more waste fluid is being removed.

12. Turn Right Dial to desired fluid type to fill the radiator making sure you don't break the

vacuum seal between the rubber cone & the radiator.

13. Flip switch to "Off" position after fluid is removed.

14. Wait until new fluid stops entering radiator & remove Cone Adapter.

15. Top off radiator if needed (see "Top-off Procedure").

16. Refill overflow bottle & replace radiator cap.

TOP-OFF PROCEDURE:

1. Connect Wand Adapter to Red Service Hose.

2. Make sure Ball Valve is closed.

3. Turn Left Dial to desired fluid type.

4. Flip Switch to "Pump On" position.

5. Open Ball Valve at the end of the Red Service Hose to regulate fluid flow.

6. Flip Left Dial and Switch to "Off" position when finished.

DRAIN TANKS PROCEDURE:

DRAIN WASTE TANK

1. Turn Right Dial to "Vacuum/Drain Waste" position.

2. Attach Wand Adapter to Black Service Hose.

3. Turn Overflow Valve on back of machine to "Drain Waste Tank Position".

4. Open Ball Valve on Black Service Hose and place into waste container.

5. Flip Switch to "Air On" position to drain waste tank.

6. When finished draining, remove Service Hose from waste container, and close Ball

Valve.

7. Flip Switch to "Off" position.

8. Turn Overflow Valve on back of machine to "Normal Service Position" to release air

pressure from waste fluid tank.

NOTE: Coolant may splash out while air pressure is being released. Keep hands and face

away from the overflow bottle.