Floe 510-20000-00 Manual Petunjuk Perakitan - Halaman 15

Jelajahi secara online atau unduh pdf Manual Petunjuk Perakitan untuk Peralatan Perahu Floe 510-20000-00. Floe 510-20000-00 17 halaman. Quick attach roll in leg conversion kit

Halaman Cetak

WITH THE CAP REMOVED FROM THE DOCK, USE A FLOE SPEED WRENCH OR 1-1/8" SOCKET AND

CORDLESS DRILL TO ADJUST THE HEIGHT OF THE DOCK SO THE BOTTOM FRAME OF THE DOCK IS

APPROXIMATELY 8" ABOVE THE WATER. *SEE NOTE ON SHEET 1. TURN THE DOCK ADJUSTING NUT

ON THE TOP OF THE DOCK CLOCKWISE TO LOWER THE DOCK AND COUNTERCLOCKWISE TO

RAISE THE DOCK. USE A LEVEL TO MAKE SURE ALL DOCK SURFACES ARE LEVEL (FIGURE 4.7). ONCE

THE DOCK IS SET IN PLACE AND LEVELED, RE-INSERT THE PLASTIC CAPS IN THE ADJUSTMENT NUT

HOLE (FIGURE 4.8).

FIGURE 4.7

CORDLESS DRILL MAY COME TO A

SUDDEN STOP WHEN THE LEG IS

FULLY EXTENDED OR RETRACTED.

BE SURE TO HAVE YOUR

CORDLESS DRILL IN CLUTCH

MODE WHEN ADJUSTING THE

LEGS. USE OF A CORDED DRILL

MAY CAUSE ELECTROCUTION.

FAILURE TO USE DRILL IN CLUTCH

MODE MAY CAUSE INJURY TO

YOUR HAND OR ARM.

NEVER ADJUST YOUR DOCK LEGS WITH AN

IMPACT WRENCH. IF YOU CAN NOT TURN

THE ADJUSTING NUT, DO NOT FORCE IT –

YOU HAVE REACHED THE END OF THE

ADJUSTMENT RANGE. DO NOT EXCEED 15

FT-LBS. APPLYING TOO MUCH FORCE TO

YOUR DOCK LEGS WILL DAMAGE THE

SHEET 15 OF 16

FIGURE 4.8

MECHANISM.