ACR STOVES FB6WB Panduan Teknis - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Teknis untuk Kompor ACR STOVES FB6WB. ACR STOVES FB6WB 9 halaman. Woodburning cast iron stove

Halaman Cetak

Assembly of the unit

This appliance is equipped with a pre-fitted manufacturers smoke exempt stop. Under

no circumstances should it be tampered with or removed unless expressly authorised

by a competent person and the appliance is not installed in a smoke exempt area.

If the appliance is to be installed in a non smoke exempt area you can

remove the restricting screw on the secondary air control (indicated by

the two holes) to allow full movement of the secondary air slider.

The appliance is supplied pre-assembled with the flue spigot in the top exit position.

If you intend to install the appliance using a rear flue connection, the blanking plate should be

swapped over as follows:

• Remove the internal baffle plate

• Remove the rear metal plate from the

back of the stove

• Remove the rear blanking plate

• Remove the flue spigot from the top

exit by removing the securing bolts

and rope seal

• Refit the rope seal and flue spigot to

the rear exit and secure with the bolts

• Refit the blanking plate to the top exit

using the rope seal and retaining bar

The stove incorporates a knock out destructive

panel (circled) that can be removed if extra

airflow is required for safe combustion.

This is located on the underside of the unit and

the bottom air intake casting can be removed by

undoing the 13mm retaining bolt.

Make sure the modified casting is replaced.

Operating your stove

Please note that during the first firing,

we recommend a small fire is lit and

that you slowly increase the

temperature to enable the various

parts to expand normally.

You may also experience fumes and a

haze being given off by the stove during

the first firing and possibly for the next

couple of firings as the paint cures. This

is normal but please ensure that the

room is well ventilated during this

period.

The appliance should not be operated in

mild weather with smokeless fuel. Under

certain weather circumstances e.g. fog

the chimney will not draw sufficiently

and could cause asphyxiation. Either

await better weather conditions or burn

wood only.

In the rare event of a malfunction due to

overheating or a chimney fire, the air

slides should be shut down completely

and the fuel allowed to burn out. In the

event of a chimney fire, once the air

slides have been closed completely, dial

999 for assistance. If the appliance has

overheated, the appliance and flue will

need to be inspected for any damage

before it can be operated again.

Always check with your dealer or directly with the manufacturer as

using the incorrect fuel may invalidate your guarantee and damage

your appliance.

Recommended Fuels

Wood: hardwood such as ash, oak and

beech which have been cut for at least 2

years and stored under shelter. The logs

should have a maximum moisture

content of 20%. Maximum log length

300mm, maximum width 125mm.

Prohibited Fuels

Green wood: i.e wood which is less

than 2 years old with a moisture content

of above 20%

Recovered wood: i.e pallets, railway

sleepers etc. These will have been

chemically treated and will pollute the

atmosphere and possibly overheat the

appliance.

Smokeless fuel: No type of solid fuel

should be used with this stove.

Housecoal or bituminous coal: these

fuels will soot up the airways of the

stove and possibly overheat the

appliance.

Petroleum based coke: over 20% -

this will overheat the appliance and

possibly damage the unit.

Liquid fuels.