FLOJET 20465035 Manual - Halaman 5

Jelajahi secara online atau unduh pdf Manual untuk Sistem Air FLOJET 20465035. FLOJET 20465035 8 halaman. Bottled water system

SANITIZE BOTTLED WATER SYSTEM AND WAND BEFORE INSERTING WAND INTO BOTTLE. To install the suction wand

into standard 5 gallon bottle, place bottle close to system and remove bottle cap, then install suction wand into bottle.

(Note: If bottle is over filled, dispense enough water to allow the suction wand to be installed to the bottom of the bottle).

Push suction wand bottle cap over bottle and push wand to bottom center of bottle.

Before the Bottled Water Dispensing System is put into service,

the system should be sanitized by following the maintenance

and sanitation clean in-place procedure.

1. Connect Power Adapter to suitable AC Power Outlet. and

connect low voltage connector to "DC IN" port on main unit.

2. Power Switch "ON".

3. Follow manufacturer's plumbing and operating instructions

when connecting commercial coffee and Tea Brewers and

refrigerators / Ice makers.

4. BLEED AIR FROM SYSTEM: Turn pump switch "ON". Water

will begin to flow. Operate the system for 30 seconds to 1

minute into a 2-1/2 gallon pail. When the air is successfully

purged from the system, a steady laminar flow of water will

stream out the end of the hose.

NOTE: Air Bleed required only on start up. Changing bottles will not require air bleed.

SUCTION WAND REMOVAL AND

CHANGING BOTTLES

Before removing suction wand from empty bottle, move

bottle to an open area outside of cabinet. Put new bottle

next to empty bottle, clean neck and cap area with

detergent, and remove cap. Remove suction wand from

empty bottle by lifting wand cap with a rocking motion

and pull cap off bottle, sliding suction wand out of the

bottle and place directly into new bottle while sliding cap

over new bottle neck.

SUCTION WAND INSTALLATION

SYSTEM START-UP

Wall Power

Transformer

Grounded Outlet

Power

Cord

Do not place suction wand on floor, counter, or sink as

this could contaminate the suction wand assembly. If

bottle is over filled, dispense enough water to allow the

suction wand to be pushed to bottom of bottle.