Flomatic FCEL Panduan Pengoperasian

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Pengontrol Flomatic FCEL. Flomatic FCEL 4 halaman.

FCEL Electric Actuator Operating Manual

When the actuator is operated for the 1

correct rotation of the motor. Otherwise serious damage may occur.

1) Place Valve position at 45 degrees by turning the handwheel , energize

the actuator to open or close and check proper valve rotation direction.

2) If Rotation direction is reverse, stop immediately and recheck wiring.

1) General

All Flomatic Electric Actuators are thoroughly tested and checked before shipment . If

installation will not occur immediately, actuator should be kept in a dry place. Please

DO NOT remove plugs from conduit entries until ready for wiring.

2) Operation

2.1) Auto/Manual Operation

Auto/ Manual Shift operation as follows:

1) Manual Override: Caution: Before engaging manual override power must be

off. Push or Pull the hand/auto declutching lever to engage clutch. (Handwheel

may have to be "jockeyed" slightly.) After engaging clutch, turn handwheel

either to "Open" or "Closed".

2) Auto Operation by Motor: Once wiring is complete actuator is ready for

operation and will instantly operate once electric power is energized. If in

manual mode when electric power is re-energized, actuator will automatically

declutch and operate.

2.2) Valve Position Indication-

Actuator Top mounted Visual position indication shows "OPEN" and "CLOSED"

valve position.

3) Wiring Connections

3.1) Top Housing Cover Removal

Remove the 4 Socket head Housing Capscrews with a hex key wrench. Lift

housing cover from actuator base. Look for wiring diagram in plastic envelope.

Caution!! Read Before Operation!!

time it is important to check the