AMD SB710 Panduan Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Perangkat Keras Komputer AMD SB710. AMD SB710 19 halaman. Based m/b for socket am2/am2+/am3 series quad core processor
Juga untuk AMD SB710: Panduan Pengguna (20 halaman), Panduan Pengguna (20 halaman)

Halaman Cetak

WARNING!

Turn off your power when adding or removing expansion cards or

other system components. Failure to do so may cause severe

damage to both your motherboard and expansion cards.

2-1 CPU Installation

This motherboard provides a socket AM2 surface mount, Zero Insertion Force (ZIF)

socket, referred to as the mPGA940 socket supports AMD AM3 processors.

The CPU that comes with the motherboard should have a cooling FAN attached to

prevent overheating. If this is not the case, then purchase a correct cooling FAN

before you turn on your system.

WARNING!

Be sure that there is sufficient air circulation across the processor's

heat sink and CPU cooling FAN is working correctly, otherwise it

may cause the processor and motherboard overheat and damage,

you may install an auxiliary cooling FAN, if necessary.

To install a CPU, first turn off your system and remove its cover. Locate the ZIF socket

and open it by first pulling the level sideways away from the socket then upward to a

90-degree angle. Insert the CPU with the correct orientation as shown below. The

notched corner should point toward the end of the level. Because the CPU has a

corner pin for two of the four corners, the CPU will only fit in the orientation as shown.

When you put the CPU into the ZIF socket, No force required to insert of the CPU, and

then press the level to locate position slightly without any extra force.

Chapter 2

Hardware Installation

Colden Arrow

CPU ZIF mPGAB Socket