AMD A75 Panduan Pengguna - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Motherboard AMD A75. AMD A75 20 halaman. Chipset based m/b for socket fm1 amd processor

WARNING!

Turn off your power when adding or removing expansion cards or

other system components. Failure to do so may cause severe

damage to both your motherboard and expansion cards.

2-1

Before using your computer, you had better complete the following steps:

1. Check motherboard jumper setting

2. Install CPU and Fan

3. Install System Memory (DIMM)

4. Install Expansion cards

5. Connect hard disk and front panel /back panel cable

6. Connect ATX Power cable

7. Power-On and Load Standard Default

8. Reboot

9. Install Operating System

10. Install Driver and Utility

(1) CMOS RAM Clear (3-pin): JBAT

A battery must be used to retain the motherboard configuration in CMOS RAM

short 1-2 pins of JBAT to store the CMOS data.

To clear the CMOS, follow the procedure below:

Turn off the system and unplug the AC power.

Remove ATX power cable from ATX power connector.

Locate JBAT and short pins 2-3 for a few seconds.

Return JBAT to its normal setting by shorting pins 1-2.

Connect ATX power cable back to ATX power connector.

Note: When should clear CMOS

1. Troubleshooting

2. Forget password

3. After over clocking system boot fail

Chapter 2

Hardware Installation

JBAT

1-2 Closed: Normal

JBAT

2-3 Closed: Clear CMOS

CMOS RAM Clear Setting