AMD DIrect SSRFR-21D Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kulkas AMD DIrect SSRFR-21D. AMD DIrect SSRFR-21D 9 halaman.

Halaman Cetak
CARE & MAINTINANCE
CAUTION
Do not use boiling water because it may damage
the plastic parts. In addition, never use a sharp
or metallic instrument to remove frost as it may
damage the cooling system and will void the
warranty. We recommend using a plastic scraper.
CLEANING YOUR UNIT
• Turn the temperature control to "OFF", unplug the
unit, and remove the food, shelf, and tray.
• Wash the inside surfaces with a warm water and
baking soda solution. The solution should be
about 2 tablespoons of baking soda to a quart
of water.
• Wash the shelf and tray with a mild detergent
solution.
• The outside of the unit should be cleaned with
mild detergent and warm water.
• Wring excess water out of the sponge or cloth
before cleaning the area of the controls, or any
electrical parts.
• Wash the outside cabinet with warm water and
mild liquid detergent. Rinse well and wipe dry with
a clean soft cloth.
CAUTION
Failure to unplug the unit could result in
electrical shock or personal injury.
VACATION TIME
Short Vacations: Leave the appliance operating
during vacations of less than three weeks.
Long Vacations: If the appliance will not be used for
several months, remove all items and turn off the
appliance. Clean and dry the interior thoroughly. To
prevent odor and mold growth, leave the door open
slightly, blocking it open if necessary.
MOVING YOUR APPLIANCE
• Remove all items.
• Securely tape down all loose items inside your
appliance.
• Turn the adjustable legs up to the base to
avoid damage.
• Tape the door shut.
• Be sure the appliance stays secure in the
upright position during transportation. Also
protect the outside of the appliance with a
blanket or similar item.
3
21" REFRIGERATOR USER MANUAL
POWER FAILURE
Most power failures are corrected within a few hours
and should not affect temperature of your appliance
if you minimize the number of times the door is
opened. If the power is going to be off for a longer
period of time, you need to take the proper steps to
protect the contents.
ENERGY SAVING TIPS
• The unit should be located in the coolest area of
the room, away from heat producing appliances,
and out of the direct sunlight.
• Let hot foods cool to room temperature before
placing in the unit. Overloading the unit forces the
compressor to run longer.
• Be sure to wrap foods properly, and wipe
containers dry before placing them in the unit.
This cuts down on frost build-up inside the unit.
• Unit storage bin should not be lined with
aluminum foil, wax paper, or paper toweling.
Liners interfere with cold air circulation, making
the unit less efficient.
• Organize and label food to reduce door openings
and extended searches. Remove as many items as
needed at one time, and close the door as soon
as possible.
WIRING DIAGRAM

TROUBLESHOOTING

Many common problems can be solved easily, saving you the time spent communicating with customer service.
Try the suggestions below to see if the issue has a simple solution.
PROBLEM
POSSIBLE CAUSE
Appliance does not operate
Appliance is not connected to a power
supply.
The appliance is turned off.
Tripped circuit breaker or a blown fuse.
Appliance is not cold enough
The temperature is not set correctly.
Temperature could require a lower
temperature setting.
The drawer was not closed completely.
Drawer is not hermetically sealed.
The condenser is too dirty.
The ventilation opening is blocked or too
dusty.
Appliance turns itself on and off
The room temperature is higher than
frequently
average.
A large amount of food has been added to
the unit.
The drawer is open too often.
The drawer is not closed completely.
The drawer gasket does not seal properly.
The light does not work
Appliance is not connected to a power
supply.
Tripped circuit break or blown a fuse.
The light was switched off on the control
panel.
Vibrations
The appliance is not properly leveled.
The appliance seems to make
The rattling may come from the flow of the
too much noise
refrigerant, which is normal. As each cycle
ends, you may hear gurgling sounds caused
by the flow of refrigerant in your appliance.
If the temperature fluctuations occur, the
contraction and expansion of the inner walls
may cause popping and cracking noises.
The appliance is not properly level.
The drawer will not close
The appliance is not properly level.
properly
The drawer was reversed and not properly
installed.
The shelves are out of position
REMEDY
Connect the appliance.
Switch on the appliance.
Switch on the circuit breaker or replace
fuse.
Check the set temperature.
Set a lower temperature.
Do not open the drawer more often than
necessary.
Close drawer properly.
Check the drawer seal and clean/
replace.
Clean the condenser when necessary.
Clear the obstructions, clean the dust.
Put the appliance in a cooler place.
Leave the appliance to work for a while
until the set temperature has been
reached.
Do not open more than necessary.
Close drawer properly.
Check the drawer seal and clean/
replace.
Connect the appliance.
Switch on circuit breaker or replace
fuse.
Switch on the light.
Level the appliance with the adjustable
feet.
Level the appliance with the adjustable
feet.
Level the appliance with the adjustable
feet.
Check the drawer hinge and reassemble
correctly.
Check the shelves and refit correctly.
4