AMD DIrect Pro Series Panduan Petunjuk Pemasangan dan Pengoperasian - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pemasangan dan Pengoperasian untuk Pembakar AMD DIrect Pro Series. AMD DIrect Pro Series 20 halaman. Round drop in pan fire pits with thermocouple piloted safety ignition (tpsi) & pro brass snowflake burner
Juga untuk AMD DIrect Pro Series: Panduan Petunjuk Pemasangan dan Pengoperasian (20 halaman), Panduan Petunjuk Pemasangan dan Pengoperasian (20 halaman), Panduan Petunjuk Pemasangan dan Pengoperasian (20 halaman)

Halaman Cetak

Valve Assembly

Control Panel

Fig. 4 Removing contents from carton.

The fire pit comes partially assembled from the factory.

The pilot tubing and thermocouple leads are 48" in total

length, therefore, when mounting the Gas Valve/Piezo

mounting plate, ensure the mounting plate is close enough

to make all connections.

Open carton and remove contents. Inspect for any damage

or missing parts.

The hardware bag includes mounting plate screws, orifice,

Piezo wires and flex connector to complete the installation.

Carefully install the fire pit into the prepared enclosure,

connect the gas line and wire according to the figure

drawings in this manual.

INSTALLING NIPPLE INTO BURNER

Before the fire pit is installed:

Install a 2" nipple and flared fitting into the bottom of

the burner. Ensure the nipple has gas rated Teflon tape

wrapped around the threads. Thread the nipple into the

burner in a clockwise manner. Secure into position.

See Fig. 5.

CONTROL PANEL MOUNTING PLATE

The control panel mounting plate is pre-assembled at the

factory with the gas valve and Piezo ignitor. On the back of

this manual is a template for use to cut an opening for the

mounting plate. Once you have determined the location of

control panel mounting plate install the gas connections

and Piezo wires as shown in Fig. 6 and secure all

connections.

Rd. Drop In Pan Fire Pits with Snowflake Burner and (TPSI) Ignition

REMOVING PARTS FROM CARTON

Carton Contents

Thermocouple Lead

Piezo Wires

Pilot Tubing

Hardware

Bag

Nipple

Flared Fitting

Fig. 5 Installing gas line to Pro Burner.

Pilot Tubing

Flex Line To Fire Pit

PAVER-CP-TPSI

(Control Panel)

Fig. 6 Installing control panel into PAVER-CP-MT mounting

plate.

Flexible Gas Line

Burner Pan

Piezo Wires

Thermocouple

Inlet Gas

REV. A

Page 8