Coastal Boat Panduan Pemilik - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Perahu Coastal Boat. Coastal Boat 13 halaman.

ASSEMBLY FOR BOATS WITH ALUMINUM DECK

Assemble the deck floor outside the boat first to get the concept of how the floor is assembled. At the same

time install the rubber grommet into the opening in the rear panel. See the images below:

(Larger boats have more than 4 panels but the assembly follows the same principles)

2. Check the inflatable Keel. If it looks out of shape or won't lie straight, it is because it has been pressed

under the weight from being in the box during shipping. Inflate the keel. It will regain its shape when

inflated. Then deflated it and it should look straight and should line up with the floor much better!

3. Inflate the boat to about 50% or until it is extremely "baggy" and only barely has its shape

4. It

WILL

help if you put something under the transom to lift the rear of the

boat off the ground by a few inches. The idea is to get the floor off the hard

surface the boat is on in order to give the bottom of the boat some "give"

which will help to snap the stringers in place. I have a roll of blankets that I

place under the boat. Some use the oars as shown in the photo. Anything to

get the bottom of the boat off the hard floor.

5. Install piece

number "1" into the

nose of the boat first

(numbers up on all

boards).

Larger images can be viewed at our web site:

http://www.coastalinflatables.com/floor_assembly.htm

6. Install deck piece

"4", make sure it

fits under the

height board

located on the

transom

7. Install deck piece

"2"

Install the last

piece ("3").

8. To do this hold the

edge of the "2" up

about 10 inches.

Fit the last piece

into the edge of "3"

and then push

them both down

so that they "snap"

into place. This

may take some

force.