Acer AC713 Panduan Pengguna - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Monitor Acer AC713. Acer AC713 13 halaman. Acer ac713: user guide
Halaman Cetak
- 1. Table of Contents
- 2. Packing List
- 3. Precautions
- 4. Installation Instructions
- 4. Swivel Base
- 4. Power Cord
- 4. Video Cable
- 5. Operating Instructions
- 5. General Instructions
- 5. Front Panel Control
- 5. How to Adjust a Setting
- 5. Adjusting the Picture
- 6. Plug and Play
- 7. Technical Support (FAQ)
- 8. Appendix A - Specifications
- 9. Appendix B - Factory Preset Timing Table
TECHNICAL SUPPORT (FAQ)
Problem & Question
Power LED is not on
No Plug & Play
Picture is fuzzy
Picture bounces or a wave
pattern is present in the
picture
The power LED is ON
(orange) but there's no video
or no picture.
Missing one of the primary
colors (RED, GREEN, or
BLUE)
41A749-786-1A 英文
Possible Solution
*Check if the Power Switch is in the ON
position
*Power Cord should be connected
*Check if the PC system is Plug &
Play compatible
*Check if the Video Card is Plug & Play
compatible
*Check if the D-15 plug pin of Video
Cable is bent
*Make sure the Monitor Drivers are
installed
*Adjust the Contrast and Brightness
Controls.
*Move electrical devices that may cause
electrical interference.
*Computer Power Switch should be in
the ON position.
*Computer Video Card should be snugly
seated in its slot.
*Make sure monitor's video cable is
properly connected to the computer.
*Inspect monitor's video cable and make
sure none of the pins are bent.
*Make sure computer is operational by
hitting the CAPS LOCK key on the
keyboard while observing the CAPS
LOCK LED. The LED should either
turn ON or OFF after hitting the CAPS
LOCK key.
*Inspect the monitor's video cable and
make sure that none of the pins are
bent.
10